
3
LOG SET INSTALLATION
Step #6
Between the rock installed during step #12 and
the center birch log are 4 pins located in close
proximity to each other. Place the first of the 2
individual rocks on the left set of pins. Look for
a gap between the front of the rock and the
leading edge of the burner, if the rock
overhangs the front of the burner the incorrect
rock has been used. (Figure 14)
Step #7
Place the second of the 2 individual rocks on the
right set of pins as shown in figure 15. The
second rock should overhang the back of the
burner. The second rock will overhang the rear
of the burner, nearly contacting the rear enamel
panel.
Step #8
Between the rock installed during step #12 and
the pair of rocks installed during steps #13 and
#14, are 2 pins. The “Y” shaped log has 2 holes
on its underside that correspond with these 2
pins. The right side of the log will rest on the pair
of logs as shown in figure 16.