Sommerkamp TS-510GT Manuale utente

CITIZENS BAND

TRANSCEIVER

2 WATT 3 CHANNEL

INSTRUCTION

MANUAL

MODEL

TS-510GT

FTZ Nr. 171 /74

SPECIFICATIONS

Circuit: Transmitting section; Crystal controlled osciiiator

Receiving section; Superheterodyne with RF

amplifier, squelch control, and

noise limiter.

Semi-Conductors: 12 Transistors, 4 Diode, 1 Varistor,

Freq. Tolérance: . ±0.005 %

Frequency: Three channels of the 27MHz Citizen’s band

channels available.

IF Frequency: 455 Hz

Input power: 2 watt

Audio Output Power: 300mW (10% Distortion)

Antenna: Single element 4.5 feet rod antenna

Speaker: 70mm PM Dynamic speaker

Battery: 8 pen-lite Batteries (12 Volts)

Dimensions: 8X "X 3 ^"X 2" (220X90X45 mm)

Weight: 1 kg with batteries

SOIVÏfVIEFlKÀfVlP ELECTRONIC

CH-6815 LUGANO BOX 130

SWITZERLANO

TEL. ОЭ1 688543 TELEX:Z0314

FEATURES

1. High frequency amplifier circuit system ’of this unit gives you excel

lent sensitivity for receiving and easy transmitting.

2. Noise limiter, and squelch for reducing ignition and other types of

interférence is adopted.

3. Exterior antenna can be used for long distance operation.

4. AC/DC converter may be used to save batteries.

5. This transceiver is designed for three channel operation.

6. External microphone can be used for easy transmitting.

7. Battery indicator is installed.

8. Equipped with a call device.

OPERATION

1. -Extend the telescopic antenna to full length before turning switch on.

2. Turn the volume control knob clockwise to the stop position.

3. Turn slowly the squelch control knob counter-clockwise till noisy

Sound is eliminated away.

4. Adjust the volume control knob turning down to the comfortable

level.

5. When transmitting, press the “PUSH-TO-TAL ” switch button located

on the left side of the case, and speak with normal voice three or

four inches distance from the microphone. Release the “ PUSH-TO-

TAL ” switch button when receiving.

6. To give an alert signal to the other party before you start voice

communications, the call device is useful.

While you press the button located above the “PUSH-TO-TAL ”

switch button, also press the “PUSH-TO-TAL ” switch button.

This will transmit a “deep” Sound and it will be heard by the other

party. After that anormal push-to-talk and release-to-listen operation

can be resumed.

- 2 ~

^ EXT. MIC. JAC

CHARGER JAC

EARPHONE JAC

SPEA ER

& MICROPONE

SQUELCH CONTROL

& ANL SW.

ВАТТ. INDICATOR

. ANT. JAC

POWER JAC

BATTERIES

This set 8 pen-lite batteries

Putting 4 in the back side and

4 in the front side.

nfŁ-Jl

1- Г-1_ Г-L i n , .

i—i 1

—+ + + +

LJ 1

_ _ +

h"izr~ —+—+

r n H —

(BAC SIDE) (FRONT SIDE)

CHANNEL CHANGE

This transceiver is designed for three channel operation. As the case

may be that the frequency condition is worse enongh for interférence

and others etc., channel can be changed and operated by the slide switch

located on the back of the unit. Make sure that both transceivers have

the slide switch in the same positon.

SQUELCH CONTROL & ANL SWITCH

1. Turn the squelch control knob counter-clockwise to the stop position.

2. If you turn up the volume, you will hear a background noise. Then

adjust the squelch control knob turning slowly down to the comfortable

level tili noisy sound is elminated away.

3. When interférence is of such magnitude that unit will not handle it,

the squelch control knob can be turned in a clockwise direction to

eliminate the noise.

In that case, the receiving and transmitting distances are reduced

with application of squelch control.

4. To receive weak signais, turn the squelch control fully counter-

clockwise so that the ANL is switched OFF.

CAUTION

1. This transceiver is a very sensitive instrument, handle it with care

and pay special attention to the antenna and speaker.

2. Carefully watch your batteries. Weak batteries mean poor operation.

Remove the batteries, if the unit is to remain idle for along period.

Do not leave the transceiver on indefinately with the AC/DC

Converter attached.

3. Although high température will not harm or effect the operation, wet

or damp conditions could. Protect it from moisture.

4. Use caution when the antenna is extended. It may bend or break

from rough treatment.

5. Be sure your set is off when not in use. Otherwise you will waste

the batteries and possibly damage the set.

4 _

PRINTED CIRCUIT BOARD PARTS LAYOUT

ROD ANTBNNA H O L D E R

ANL ON-OFF

SW.

77 /?7Г7. SWITCH 1

©W

CRYSTAL A.^/2

&J S

MIC.TMHS

T 7

IN P U T TRANS !

©< 0

METER HOLDER

- 5 -

SCHEMATIC DIAGRAM

R/9 /2к

- 6 - 4 - 7 -

PRINTED CIRCUIT BOARD PARTS LAYOUT

BOTTOM VIEW

iAf'30^

Hüb® f ®9

<1 ,Г200Р

2SC/ /8 -

Б В :C<

H U h » J ^ZSCWS • •

■ H 0 H T \ 1 # L . U i J j

/э - f 1 •

r. . я

tN60

х т а 60; i - x

f T« v« «к

“T

* 4'2

/. Г * .04 7 T

HH» *

l& r

liz a -* li— =J ^ r ™ b

___

,г ш ^ 4 E

Y . V JOK В ‘ ’ s

~o N

WIRING LAYOUT

ВАТТ- SSAP яе0

- 9 -

PARTS LIST for TS-5I0GT

DESIGNTION PARTS NAME PARTS N0.

MP-201 Cabinet Case Body 481003

MP-202 Cabinet Case Back 473004

MP-203 Front Pannel 482004

MP -17 nob for VOL, SQU, 474011

MP-204 P. T, T. Button 473001

MP-205 Rod Antenna Base 474013

MP-206 Rod Antenna Holder 474012

MP-207 Battery Case Holder 473003

MP-208 Screw for Case Back 474004

MP-209 Mounting Bracket for Speaker 474009

MP-210 Mounting Bracket for Channel SW. (B) 474008

MP - 211 Mounting Bracket for Channel SW. (C) 484112

MP - 212 Hinge 474003

MP - 213 Mounting Bracket for Hinge 484052

MP - 214 Mounting Bracket for Front Pannel 484055

MP - 215 Meter Holder 484060

MP - 216 Front plate 484155

MP - 217 Brand plate 484156

MP - 218 Back plate 484158

MP - 219 Screw for Rod Antenna 484160

PP-201 Carrying Case CC- 510

PP-203 Instruction Manual IM-510GT

TR6 Transistor 2SA562 (0)

TR2 Transistor 2SC710(C)

TRI,3,4,5 T ransistor 2SC710(D)

TR7, 8 ' Transistor 2SC712 (C)

TR9. 10 Transistor 2SC496 (0)

TR11 ! Transistor 2SC495 (T)

TR12 ! Transistor 2SC1018

- io

Indice

Altri manuali Sommerkamp Ricetrasmettitore

Sommerkamp

Sommerkamp FT-250 Manuale utente

Sommerkamp

Sommerkamp TS-727G Manuale utente

Sommerkamp

Sommerkamp TS-340 Manuale utente

Sommerkamp

Sommerkamp TS- 5612 Manuale utente

Sommerkamp

Sommerkamp TS 288A Manuale utente

Sommerkamp

Sommerkamp TS-630S Manuale utente

Sommerkamp

Sommerkamp TS-727GT Manuale utente

Sommerkamp

Sommerkamp TS 1608 G Manuale utente

Sommerkamp

Sommerkamp TS-712 Manuale utente

Sommerkamp

Sommerkamp TS-340 DX Manuale utente

Sommerkamp

Sommerkamp TS-5680 Manuale utente

Sommerkamp

Sommerkamp TS-206MT Manuale utente

Sommerkamp

Sommerkamp TS- 5632 Manuale utente

Sommerkamp

Sommerkamp TS-788DX Manuale utente

Sommerkamp

Sommerkamp TS-660S Manuale utente

Sommerkamp

Sommerkamp TS-664S Manuale utente

Sommerkamp

Sommerkamp TS 624S Manuale utente

Sommerkamp

Sommerkamp TS 288A Manuale utente

Sommerkamp

Sommerkamp FT-277 Manuale utente

Sommerkamp

Sommerkamp TS-727G Manuale utente

Sommerkamp

Sommerkamp TS-780DX Manuale utente

Sommerkamp

Sommerkamp TS -1122FM Manuale utente

Sommerkamp

Sommerkamp TS-680EDX Manuale utente

Sommerkamp

Sommerkamp FT DX-500 Manuale utente

Manuali Ricetrasmettitore popolari di altre marche

Yaesu

Yaesu FT-7B Manuale utente

Kenwood

Kenwood ProTalk TK-3201 Manuale utente

Texas Instruments

Texas Instruments TLK10232 Manuale utente

Mizuho

Mizuho MX-2 Guida del prodotto

Kenwood

Kenwood TK-3180 Manuale operativo e di manutenzione

Blitz

Blitz MJ-398U Manuale utente

Utilicom

Utilicom LongRanger 2050 Manuale utente

Standart

Standart HX290UKA Manuale utente

Altronix

Altronix Pace1PTM Manuale utente

Kirisun

Kirisun PT2208 Manuale utente

ELECRAFT

ELECRAFT KX2 Manuale utente

Zodiac

Zodiac K3 Manuale utente

Assa Abloy

Assa Abloy SecureComm HKC GSM-WIFI U Manuale utente

Kenwood

Kenwood TK-2217 Manuale utente

Siemens

Siemens PSO 4000 Manuale utente

Kenwood

Kenwood TS-590SG Manuale utente

Midland

Midland G8E-BT Manuale

ComNav

ComNav Mariner X2 Manuale utente