SONARAY WP-5040 Manuale utente
PRODUCT
PHOTO
MODEL
NUMBER WP-5040 WP-5060 WP-5080 WP-5100 WP-5120 WP-5150
POWER
CONSUMPTION 40W 60W 80W 100W 120W 150W
OPERATING
VOLTAGE 100-277V AC ~ 50/60Hz
HOUSING
MATERIAL Aluminum
OPERATING
TEMPERATURE -20°C ~ +50°C / -4°F ~ +122°F
IP
RATING 65
DIMENSIONS 14.56 x 9.05 x 7.48 18.30 x 9.29 x 8.97
Non Cuto Wall Pack Light Installation Guide
ATTENTION
INSTALLATION PREPERATION
1. Take out the luminaire from the box and place it on a level platform for easy installation.
2. For proper operation, a qualied electrician should perform the installation.
3. Ensure the normal ambient temperature of the installation location is between -20°C ~ +50°C.
4. Ensure the voltage of the luminaire is capatable with the onsite voltage before installation.
5. Any luminaire with damaged power cord should not be installed.
Note: The power must be cut off before installation.
TECHNICAL PARAMETERS
REV: 21 0101 0000
TYPEDATE
PROJECT
NOTES
www.sonarayled.com
®
©2021 | SONARAY LED LIGHTING HEADQUARTERS | 34 LAKEVIEW COURT VERONA, VA 24482 USA | OFFICE 844.202.5606 | FAX 540.242.7221
This manual instructs the important information of installation and operation. Be sure to strictly follow
the instructions before use. To ensure correct installation and operation of the product, carefully read
and understand all contents of this guide. Any mechanical or electrical modications to the product
will void warranty and may cause dangerous hazards. To avoid potential issues caused by high
temperature, be sure no objects are on the lens while the product is switched on.
SITUATION POSSIBLE REASON POSSIBLE SOLUTION
LED
DOES NOT
LIGHT UP
Incorrect input wiring Conrm wire colors
No power to the luminaire Recycle power or check power connection
Incorrect voltage Conrm voltage
LED
FLICKER
Poor power connection Check power connection
Input voltage uctation Conrm voltage
TROUBLESHOOTING
GENERAL MAINTENANCE
Make sure there is no power running to the luminaire when performing maintenance.
The lens and the housing can be cleaned using a soft cloth without any corrosive material.
Non Cuto Wall Pack Light Installation Guide
INSTALLATION DIAGRAM
REV: 21 0101 0000
TYPEDATE
PROJECT
NOTES
www.sonarayled.com
®
©2021 | SONARAY LED LIGHTING HEADQUARTERS | 34 LAKEVIEW COURT VERONA, VA 24482 USA | OFFICE 844.202.5606 | FAX 540.242.7221
1. Be sure that the power is turned o before
installation.
2. Remove the upper cover from the xture by unscrewing the
two screws on the side.
3. Drill two holes on the wall then drill the correspaonding
holes into the xture’s base plate using the dimensions above.
Please note the unit of measurement is in mm.
4. Install the base plate onto the wall and fasten with the
three screws provided.
5. Pull the wiring through the hole in the base plate and
make the connection.
6. Connect the xture housing back onto the base plate by
re-attaching the two screws on the side.
Questo manuale è adatto per i seguenti modelli
5
Altri manuali SONARAY Attrezzatura di illuminazione
