Sony SRG 300 Manuale utente
SKAARHOJ DEVICE CORES
Device: Sony SRG 300
Introduction
A large number of parameters can be controlled on the Sony SRG 300cameras.
This integration was done using Sony SRG 300 software version 1.0.
Please see the “PTZ Manual” at https://www.skaarhoj.com/support/manuals/ to learn more about PTZ
control in general from SKAARHOJ controllers and in particular network recommendations.
In this manual it is worth noticing that one should not add additional Device Cores to control multiple
cameras. This is possible from the same Device Core but proper steps should be ensured (consecutive IP
addresses on the cameras) for a good user experience.
Number of Cameras possible to control
Please notice from the Sony SRG 300 Device Core it is possible to control up 7 cameras. In general this is
the limit for our VISCA over IP Device Cores and our integration have not been tested above 7 cameras. If
you want to control more than 7 cameras you will need to add an additional Device Core and configure
the controller accordingly. None of our default configuration utilities 2 x Sony SRG 300 Device Cores. As
we have never tested with more than 7 cameras, we do not know how performance and stability will be in
such a configuration setup. We recommend only having 1 x Sony SRG 300 Device Core installed per
controller.
1
SKAARHOJ DEVICE CORES
Confirm Connection
The Serial Monitor from the Firmware Application can be used to monitor connection status.
Device Configurations
Device configuration options exist:
-Index 0: VISCA over IP/Serial
-If “1” = VISCA over Serial
Example:
Enabling VISCA over serial could look like this device configuration code: “D0:0=1” where the general
form would be “Dx:y=z” where “x” is the number of the device core as installed on the controller (starting
with zero for the first device core), “y” the index number and “z” the value for that index.
If the Sony SRG-300 Device Core is the first like below:
Setting VISCA over serial would be set by this configuration under “Manage Media” on the configuration
page for your controller. Access this by pressing “Online Configuration” in the Firmware Application.
Remember to save on the configuration page and press “Check for updates” in the Firmware Application.
2
SKAARHOJ DEVICE CORES
To confirm that a device configuration is in fact detected by the controller, please check it out on the serial
monitor where it will be mentioned:
Dip Switches
There are multiple dip switches on the bottom of the Sony SRG-300 to control connection via IP or Serial.
3
Switch
LAN
VISCA
1
On
Off
2
Off
Off
3
Off
Off
4
Off
Off
5-8
Off
Off
SKAARHOJ DEVICE CORES
Ethernet to Serial connection
To communicate via serial (RS-232C) to the Sony SRG-300 camera you need an Ethernet-Serial converter.
We suggest you get a USR-TCP232-306 from USR IOT - https://www.pusr.com/products/ethernet-to-serial-
converters-usr-tcp232-306.html
Below you will find screenshots of how to configure the USR-TCP232-306 converter (found of the web
interface of the USR-TCP232-306). Notice the IP address of the USR-TCP232-306 (Static IP Address) must
match the IP settings of the SRG-300 Device Core.
In the settings below the Baud Rate is set to 9600 and Serial Type to RS232. The camera must match these
settings.
Actions
An excerpt of the actions in the Device Core
4
Indice
Altri manuali Sony Telecamera di sicurezza
Sony
Sony SNC-VB635 Manuale utente
Sony
Sony SNC-RH164 Manuale utente
Sony
Sony Ipela SNC-CS50N Manuale utente
Sony
Sony FCBEX1000 Manuale utente
Sony
Sony SuperExwave SSC-CD77P Manuale utente
Sony
Sony SNC-RH164 Manuale utente
Sony
Sony XCHR90 Manuale utente
Sony
Sony FCB-PV480 Manuale utente
Sony
Sony IPELA SNC-RZ50N Manuale utente
Sony
Sony IPELA SNC-HM662 Manuale utente
Sony
Sony FCBIX45C Manuale utente
Sony
Sony IPELA SNC-RX550NP Manuale utente
Sony
Sony SNC-RS44N Manuale utente
Sony
Sony XCD-SX900 Manuale utente
Sony
Sony IPELA EXWAREPRO SNC-DM160 Manuale utente
Sony
Sony IPELA SNC-P5 Manuale utente
Sony
Sony IPELA SNC-CH110 Manuale utente
Sony
Sony IPELA SNC-DF40N Manuale utente
Sony
Sony IPELA SNC-CH110 Manuale utente
Sony
Sony DynaView SSC-CR441 Manuale utente
