Speco CVC-647TP Manuale utente
P. 1
CVC-647TP
Vandal Resistant Dome
Camera Instructions
CONTENTS
Page Page
1. DESCRIPTION……… ........ 1
2. INSTALLATION………….... 2
3.WIRING INSTRUCTIONS ... 3
4. SPECIFICATIONS.............. 4
1. DESCRIPTION
Thank you very much for purchasing our product.
This Tamper Resistant Color Dome Camera uses a SONY Super-HAD
CCD Image Sensor and solid-state circuitry, which provides long life and
high reliability. This CVC-647TP offers excellent image quality with low
lag and high burn resistance, and is not subject to distortions from
magnetic fields. Highly resistant to shock and vibration, and easy to install,
this Camera is a very good choice for your CCTV system.
P. 2
2. INSTALLATION
STEP 1: Please select the most suitable position on the ceiling to install
the camera.
STEP 2: Remove the locking screw and rotate the dome housing
counterclockwise to remove it from the mounting base (as shown
by the figure below).
Mount i ng Base
DOME Ho u s i ng
OR
STEP 3: Hold the mounting base against the ceiling and center it over the
cable hole. Attach to the ceiling using the four screws supplied in
the accessory package (shown by the figure below).
Then allow the cable connectors to pass through the cable entry
hole made available for that purpose (shown by figure below).
STEP 4: Set the proper image angle by adjusting the camera body.
When the camera angle adjustment has been completed, rotate the
dome housing clockwise to secure it to the mounting base.
STEP 5: Lock the dome cover into position using the Locking screw.
3. WIRING INSTRUCTIONS
STEP 1: Connect a coaxial cable between the camera and the monitor
using a 75-Ohm coaxial cable with 95% copper shielding.
STEP 2: Plug the Power Adapter into an AC socket and the DC plug into
the DC Jack of the camera. Please note that the center pin is
positive (+).
TO MONI T OR
TO DC POWER SOURCE
P. 3
.
4. SPECIFICATIONS
Camera Type Color High Resolution
Image Pick-up Device SONY 1/4” Super-HAD CCD sensor
Effective Picture
Elements (HxV) NTSC: 510x492
Horizontal Resolution 380 TV lines
Minimum Illumination 0.5 LUX @ F2.0
S/N Ratio More than 50 dB
Auto Electronic Shutter NTSC: 1/60s~1/100,000 sec
Gamma Characteristic 0.45
Lens Furnished Board lens f 3.6mm / F 2.0
(Optional: f 2.5 / 4.3 / 6.0 / 8.0 / 12 /mm)
Auto Gain Control Yes
Auto White Balance Yes
Synchronous System Negative sync. Internal.
Video Output 1 Vp-p / 75 Ohms. (BNC Connector
Power Supply UL/CSA 12-Volt DC Regulated Supply included
Power Consumption 120 mA
Operating Temp. -10℃to 50℃(14℉to 122℉)
Note: Design and specifications are subject to change without prior notice.
Speco Technologies
200 New Highway
Amityville, NY 11701
Tel: 631-957-8700
Fax: 631-957-9142
www.specotech.com
2003/11/03 040024B by SPECO Technology
P. 4
Altri manuali Speco Telecamera di sicurezza
Speco
Speco O4FB1M Manuale utente
Speco
Speco O4iT1 Manuale utente
Speco
Speco CVC637HW Manuale utente
Speco
Speco HTB11FFi Manuale utente
Speco
Speco O5D2M Manuale utente
Speco
Speco O5B2 Manuale utente
Speco
Speco O8FT1W Manuale utente
Speco
Speco HT-INTD3 Manuale utente
Speco
Speco VL-262SD Manuale utente
Speco
Speco O4VT1NG Manuale utente
Speco
Speco CVC5300DPVF Manuale utente
Speco
Speco VL-66 Manuale utente
Speco
Speco CVC-614C Manuale utente
Speco
Speco O6MDP3 Manuale utente
Speco
Speco CVC-927PTZ Manuale utente
Speco
Speco ProVideo CVC-7700DN Manuale utente
Speco
Speco VL-INTT5 Manuale utente
Speco
Speco O2iMT61 Manuale utente
Speco
Speco TC-24/2.9 Manuale utente
Speco
Speco O4B9M Manuale utente
