SpeechWare FlexyMike FMK03 Manuale di istruzioni
Connection of theFlexyMike Bluetooth Transmitter (FMK03)
under Windows Vista or Windows 7
(without any other third party software!)
1. BASIC OPERATING INSTRUCTIONS
Our models FMK03
(http://www.speechware.be/en/verArticulo.php?id=1671) --and
FMK04--
feature a
couple of Light Emitting Diodes (LEDs), which lights up in Blue
(
B-LED
)
and Red
(
R-LED
)
colour, with
the following meaning:
•
••
•
B-LED
flashing twice quickly every 2 sec.: Power On and "Standby" (low consumption) mode
•
••
•
B-LED
flashing once slowly every 2 sec.:
"Link" (transmission) mode
•
••
•
B-LED
/
R-LED
flashing alternatively:
"Pairing" mode
to establish a connection
for the first time
•
••
•
R-LED
flashes quickly (while using it): Low battery mode
•
••
•
R-LED
lights on: Charging mode
•
••
•
R-LED
flashes twice quickly and stops: Power Off mode.
2.INSTALLATION OF FULL DUPLEX BLUETOOTH TRANSMITTER
(FMK03)
UNDER
WINDOWS VISTA OR WINDOWS 7 (WITHOUT ANY THIRD PARTY SOFTWARE)
a) Put the FlexyMike Bluetooth Transmitter in "Pairing" mode (check above): press the On/Off
button for about 5 s. and until the
B-LED
/
R-LED
flash alternatively. Make sure that before you
press the On/Off button, the Transmitter is Off.
b) Check for the Bluetooth icon of your Windows bar (
in the bottom right hand corner of your screen):
If you cannot see it, then Bluetooth may be disabled. To enable it, select
Start > Control Panel >
Wireless Assistant
and press enable (“Allumer”) Bluetooth in your computer:
If you do not see a Bluetooth item in your Control Panel, it may need to be installed!
c) Right-click on the aforementioned Bluetooth icon of your Windows bar, and select the option “Add
peripheral”
(“Ajouter un périphérique”):
d) When the Bluetooth Transmitter
(FMK03)
is automatically detected by Windows Vista or 7, after a couple of
minutes, itappears in this screen. Click next:
e) In this screen, left-click or select the second option:
f) Insert the pin number "1234" and press “Submit”:
g) Click “Fermer” in the last window:
Now, your FlexyMike Bluetooth microphone is ready to be used under Windows Vista or 7!
3. HOW TO CONNECT AGAIN THE FULL DUPLEX BLUETOOTH TRANSMITTER
(FMK03)
WHEN RESTARTING THE PC
If you need to establish again the Bluetooth connection, afterrestarting the PC,follow the next steps:
a) With the Bluetooth Transmitter switched On, right-click on the Bluetooth icon of Windows bar and
select now “Show the Bluetooth peripherals” (“Afficher les périphériques Bluetooth”):
b) Double-click on the SpeechWare microphone icon:
c) If there is no connection, in the next window, press “Connect” (“Connecter”)
d) When the connexion is established again, the window will show it:
Altri manuali per FlexyMike FMK03
2
Indice
Altri manuali SpeechWare Trasmettitore
