info@splashmonitoring.com www.splashmonitoring.com
DL2 Basic Configuration
Note: It takes about a minute for the DL2 to power up, during which time nothing apparentlyhappens –be patient!
Install the Service Center Program
Once you have connected all the devices together as shown and powered them up, connect a PC to the network, insert
the CD labelled ‘Service Center Software’ provided with the DL2 and allow it to automatically install the Service Centre
Software. If it doesn’t automatically invoke the installation program a short while after you insert the CD, then go to ‘My
Computer’, right-click the DC-ROM icon and select ‘Explore’. Then double-click on the ‘ServiceCenterLightSetup.exe’ file
and follow the instructions on the screen. These steps are set out in pictoral detail in the DL2 manual accessed from the
CD as described in paragraph one above.
Choosing an IP Address:
By default the STREAMbox will scan IP addresses aaa.bbb.ccc.210 through aaa.bbb.ccc.219, where aaa.bbb.ccc is the
network address provided by your router. You can find this address by going to the command prompt on your network
attached Windows PC and typing “ipconfig /all” at the command prompt. You should see something like:
Take the first three octets from the Default Gateway address (192.168.12) in the above example and add .210 to the end.
Therefore the IP address for the first DL2 in this example will be 192.168.12.210. Subsequent Bootloaders attached to the
same network will be given IP addresses of 192.168.12.211, 192.168.12.212 and so on.
Run the Service Center Program
On your computer go to ‘Start’ -> ‘All Programs’ -> ‘Resol’ -> Service Center light’ and click on ‘Service Center light’
In the lower left drop-down menu next to ‘Port name’ select ‘Connect to DL2’, then press the ‘Connect’ button.
This should bring up a window ‘RESOL Device Discovery’ and in the ‘Discovered RESOL Devices on the Local Network’
pane there should be an entry something like ‘DL2-001E6600FFA (192.168.0.112)’. Click on this to highlight it and the IP
address should appear in the ‘DL2 Remote Address’ pane. Make a note of the IP address.
Configure the DL2
Enter the IP address you noted into yourWeb Browser address pane.
You will be asked for a username and password, the factory defaults are ‘admin’ and ‘admin’ respectively.
Note: DL2v2 navigation is slightly different from the description below, follow the instructions in [square brackets]
Select the ‘Configuration’ tab:
Select the ‘General’ tab you may want to reset the ‘admin’ password at this point.
