SpreadNet SN960-PENDANT Manuale utente
SpreadNet
Model SN960-PENDANT
RF Personal Protection Transmitter
InstallationInstructions
The SpreadNet Model SN960-PENDANT Personal Transmitter is a truly
versatile wireless RF transmitter.
UsingSpreadSpectrumtechnology,theSN960-PENDANTprovideshigher
power,lowernoiselevels,lessinterference,andlongerrangethanobtain-
able with most single-frequency RF transmitters, resulting in increased
reliability.
The unit is equipped with two push buttons mounted on the sides of the
assembly. The transmitter is activated by pressing both buttons simulta-
neously.
UL COMPLIANCE
For Grade A household burglar alarm and household fire warning system
applicationsusing theC&K System2316 ControlPanel:
Onlyone transmitter may be installed perzone.
FEATURES
•SpreadSpectrumTechnology •Waterresistant
•SimpleInstallation •ProgrammableCheck-InRate
• EEPROMMemory •Includes Neck Chain and Belt
clip
•2push buttons wired
in series • LithiumBattery(Included)
•10mW TransmitterPower •Up to 3-year Battery Life
The SN960-PENDANT comes with an adjustable bead chain (P/N 7-700-
000-00) and a belt clip (P/N 5-532-111-00), both included. To install the
chain, open the chain and insert the end through the opening across the
top of the Pendant. (See Figure 1 below.) Remove excess chain length
bycuttingoffextrabeadswithapairofwirecutters.ThisallowsthePendant
to be worn around the neck.
ThePendant also comes supplied with anoptional belt clip, which may be
inserted into the back of the Pendant. (See Figure 1 below.)
PROGRAMMING THE PENDANT
To program the SN960-PENDANT, open the battery compartment and
remove the Battery Activator Tab from the positive (+) end of the battery.
Next,connecttheSN900-PROGHandheldRFProgrammertotheProgram-
mingConnectorandfollowtheprogramminginstructionsasoutlinedinthe
SN900-PROG Programming Manual (P/N 5-051-136-00).
TESTING THE PENDANT
To Walk-Test the SN960-PENDANT, move about in the various areas to
be protected, activating the Pendant in each area to ensure reception at
all positions to be covered. To activate the transmitter, press both Alarm
Activator Buttons on the sides of the Pendant at the same time.
NOTE:For continued reliability, the SN960-PENDANT should be
tested at least once per year.
SPECIFICATIONS
• Dimensions: • OperatingEnvironment:
2.75" L x 1.875" W x 0.875" D 32° to 140° F (0° to 60° C);
(7 cm x 4.75 cm x 2.2 cm) upto 95%relative humidity
(non-condensing)
•Weight:
2 oz. (57 g) • RFEmissionStandards:
USA: FCC Part 15
• OperatingFrequency: CANADA: IndustryCanada
902 - 928 MHz Spread Spectrum • Supervisory Rate:
• Input Power: 30 - 300 sec (30 sec intervals)
one6 VDC 1/2AA lithium battery 0 isunsupervised
• Output Power: • NeckChain
10mW P/N7-700-000-00
transmittingperiod -7.6 mSec • Belt Clip
• Replace Batteries Only with P/N5-532-111-00
C&KModel #SN60L-BAT
Duracell XL PX 28L
NOTE: Batteries should be replaced
following a low battery indication or
every 3 years, whichever occurs first.
®
AlarmActivator
Buttons
Programming
Connector
Battery
Compartment
Battery BeltClip
Neck Chain
RetainerSleeve
Neck
Chain
Battery
Compartment
Battery Compartment
Retaining Screws
Figure 1 - Transmitter Housing
C&K is a registered trademark of C&K Components, Inc. Printed in Hong Kong P/N 5-051-270-00 Rev B
SpreadNet is a registered trademark of C&K Systems, Inc.
Copyright 1995 C&K Systems, Inc. US Patents 4,977,677; 5,067,136; 5,095,493; and 5,119,396
All Rights Reserved
FCC NOTICE
TheModelSN960-PENDANTPersonalProtectionTransmittergeneratesand
usesradiofrequencyenergy. Ifnotinstalledandusedinaccordancewiththe
manufacturer'sinstructions,itmaycauseinterferencetoradioandtelevision
reception. ThePendantTransmitterhasbeentestedandfound tocomplywith
thespecificationsinPart15ofFCCRulesforClassBComputingDevicesand
FCC Part 15 Subpart C, Specifications for Intentional Spread Spectrum
Radiators.
Ifthis equipment causes interference toradio or television reception - which
can be determined by turning the equipment on and off - the installer is
encouraged to correct the interference by one or more of the following
measures: 1) Reorienttheantennaoftheradio/television. 2) ConnecttheAC
transformertoadifferentoutletsothecontrolpanelandradio/televisionareon
differentbranchcircuits. 3) Relocatethecontrolpanelwithrespecttotheradio/
television.
If necessary, the installer should consult an experienced radio/television
technicianforadditionalsuggestions,orsendforthe"InterferenceHandbook"
prepared by the Federal Communications Commission. This booklet is
availablefromtheU.S.GovernmentPrintingOffice,WashingtonD.C.,20402,
stocknumber004-000-00450-7.
CAUTION: C&Kdoesnotsupportfieldchangesormodificationstoanyofthe
SpreadNetRFequipmentunlesstheyarespecificallycoveredinthismanual.
Alladjustmentsmustbemadeatthefactoryunderthespecificguidelinesset
forthinourmanufacturingprocesses. Anymodificationtotheequipmentcould
voidtheuser'sauthorityto operatetheequipmentandrender theequipment
in violation of FCC Part 15, Subpart C, 15.247.
This device complies with Part 15 of the FCC Rules. Operation is subject to
thefollowing two conditions: (1) thisdevice maynot cause harmfulinterfer-
ence, and (2) this device must accept any interference received, including
interferencethatmaycauseundesiredoperation.
IndustryCanada
This digital apparatus does not exceed the Class B limits for radio noise
emmissions from digital apparatus as set out in the Radio Interference
RegulationsoftheCanadianDepartmentofCommunications.
Leprésentappareilnumérquen'émetpasdebruitsradioélectriquesdépassant
leslimitesapplicablesauxappareilsnumériquedeClasseBprescritesdans
le règlement sur le brouillage Radioélectrique édicté par le Ministère des
CommunicationsduCanada.
LIMITEDWARRANTY
Seller warrants its products to be in accordance with its own plans and specifications and to
be free from defects in materials and workmanship under normal use and service for 18
months fromthedatestampcontrolontheproduct; or for products not having a C&K Systems
date stamp, for 12 months from the date of original purchase, unless the installation
instructions or catalogue sets forth a shorter period, in which case the shorter period shall
apply.
Seller's obligation shall be limited to repairing or replacing, at its option, free of charge for
materials or labor, any part which is proved not in compliance with Seller's specifications or
proves defective in materials or workmanship under normal use and service. This warranty
is void if the product is altered or improperly repaired or serviced by anyone other than an
authorized C&K factory service center. Contact your local C&K distributor for the service
center location nearest you.
THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR
FITNESS FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND
THE DESCRIPTION ON THE FACE HEREOF. In no case shall Seller be liable to anyone for
any consequential or incidental damages for breach of this or any other warranty, express or
implied, or upon any other basis of liability whatsoever, even if the loss or damage is caused
by Seller's own negligence or fault.
Seller does not represent that its product may not be compromised or circumvented; that the
productwillpreventanypersonalinjury orpropertylossbyburglary,robbery,fire,or otherwise;
orthattheproductwillinallcasesprovideadequatewarningor protection. Buyer understands
that a properly installed and maintained alarm system may only reduce the risk of burglary,
robbery, or fire without warning, but it is not insurance or guarantee that such will not occur or
that there will be no personal injury or property loss as a result. CONSEQUENTLY, SELLER
SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE, OR
OTHER LOSS BASED ON A CLAIM THAT THE PRODUCT FAILED TO GIVE WARNING.
However, if Seller be held liable, whether directly or indirectly, for any loss or damage arising
under this Limited Warranty or otherwise, regardless of cause or origin, Seller's maximum
liability shall not in any case exceed the purchase price of the product, which shall be fixed
as liquidated damages and not as a penalty, and shall be the complete and exclusive remedy
against Seller.
This warranty replaces all previous warranties and is the only warranty made by C&K on this
product. No increase or alteration, written or verbal, of the obligation of this warranty is
authorized.
Indice
Altri manuali SpreadNet Trasmettitore
