Squareled Moving Blade Manuale utente

User Manual: Squareled Moving Blade 1500W IP65

SquareLED Moving Blade

1500W IP65 LED Strobe

USER MANUAL

INTRODUCTION

Thank you for having chosen our LED lighting

Unpack the device, inside the box you should find:

The fixture device

One power cable

One XLR connection cable

This manual

Please check carefully that there is no damage caused by

transportation. Should there be any problems, consult your dealer and

don’t install this device.

DESCRIPTION

Features

572pcs 1W RGB LEDs&144pcs 8W white LEDs，no ultraviolet

radiation.

More than 20,000 hours for the LED light source

100,000 luminous

120 degrees

3/12/16/28/75/60/6/14/50/60/23 /18/30 DMX channels

16 Bit Dimmer

DMX Mode/Master-Slave mode/Pixel mode

12-segment RGB +12-segment white pixel modes can be used as

wash (brightness: 300W RGB/ 1000W white)

The 12-segments white LEDs generate a strobe pulse with

brightness equivalent to a 3000W conventional STROBE!

Intense built –in strobe programs

AC200-240V 50/60Hz 1500W

Diecasting heatsink with fans Control

With temperature sensor to extend the lamp's life

8000 Hz LED scan rate

L: 490 W: 313mm D: 123 mm

IP65

SAFETY INSTRUCTIONS

This device has left the factory in perfect condition. In order to

maintain this condition and to ensure a safe operation, it is

absolutely necessary for the user to follow the safety

instructions and warning notes written in this user manual.

This device falls under protection-class I. Therefore it is essential that

the device should be earthed.

The electric connection must carry out by qualified person.

If the external flexible cable or cord of this luminaire is damaged, it

shall be exclusively replaced by the manufacturer or his service agent

or a similar qualified person in order to avoid a hazard.

Make sure that the available voltage is not higher than stated at the

end of this manual.

Make sure the power cord is never crimped or damaged by sharp

edges.

If this would be the case, replacement of the cable must be done by an

authorized dealer.

Always disconnect from the mains, when the device is not in use or

before cleaning it. Only handle the power cord by the plug. Never pull

out the plug by tugging the power cord.

Never look directly into the light source, as

sensitive persons may suffer an epileptic shock.

Important:

Damages caused by the disregard of this user manual are not

subject to warranty. The dealer will not accept liability for any

resulting defects or problems.

DMX-512 control connection

The product has a DMX 512 input fitted with 3-pin XLR connectors.

Screened cables in compliance with EIA RS-485 specifications and the

following characteristics must be used for connections:

- 2 conductors plus screen

- 120Ohm impedance

- low capacitance

- max. transmission rate 250kBaud.

DMX-512 connection with DMX terminator

For installations where the DMX cable has to run a long distance or is

in an electrically noisy environment, such as in a discotheque, it is

recommended to use a DMX terminator. This helps in preventing

corruption of the digital control signal by electrical noise. The DMX

terminator is simply an XLR plug with a 120 OHM resistor connected

between pins 2 and 3, which is then plugged into the output XLR

socket of the last fixture in the chain.

Display Menu

Main menu

Sub-menu

Address

DMX Address Setting

Config Mode

channel mode

Channel 3 CH

Channel12 Ch

Channel 16 Ch

Channel 28 Ch

Channel 75 Ch

Channel 60 Ch

Channel 6 Ch

Channel 14 Ch

Channel 50 Ch

Channel 23 Ch

Channel 18 Ch

Channel 30 Ch

keep screen on

Disable/enable

keep DMX data

Disable/ enable

Fan speed

Standard/ High/ Low

Fast Dimmer

Disable/ enable

System Info

Temperature

Head

Body

LED load Default

False/True

LED All On

Auto Test

auto 1

auto 2

auto 3

Manual Test

red

0-255

green

0-255

blue

0-255

white

0-255

Tilt

0-255

Fan Test

Fan1

On/ Off

Main functions

1. Address: Current DMX address

A. Setting DMX address by button

press ENTER button when show the address menu, then adjust

the DMX address by pressing [UP] or [DOWN] button

Press [ENTER] to confirm or press [ESC] to return to main menu.

B. Setting DMX address by controller

1.Set the DMX value of channel 5 to 10-15,channel 17 to 20-26,

channel 7 to 30-36,channel 8 to 40-46,then the devices

connected to the controller will enter to the setting address mode

2. Set the DMX value of channel 1 from 0-59,then you will see

the first number of the Address change to (channel 1 value)/10.

For example, when set the value of channel 1 to 20,the first DMX

address number will be 2(20/10=2),

3. Set the DMX value of channel 2 from 0-99,then you will see

the second number of the Address change to (channel 2

value)/10.

For example, when set the value of channel 2 to 30,the first DMX

address number will be 2(30/10=3),

4.Set the DMX value of channel 3 from 0-99,then you will see the

third number of the Address change to (channel 3 value)/10.

For example, when set the value of channel 1 to 40,the first DMX

address number will be 3(40/10=4),

And the DMX address you set by controller will be 234.

5. Set the DMX value of channel 4 to 255,then you will save the

DMX address settled by the controller.

Caution: It won’t save the address if the address number is

over 512

6. set the value of channel 5-8 out of the value range show on the

step 1,and the device will exit the setting address mode

2. Config.

Setting DMX mode

press ENTER button when show the channel menu, then select

the DMX mode by pressing [UP] or [DOWN] button

Key mode

press ENTER button when show the key mode menu, then

select lock or unlock by pressing [UP] or [DOWN] button

Show Temperature

press ENTER button when show the Temp Unit CS menu, select

the way of showing the fixture’s temperature in ℃or ℉by

pressing [UP] or [DOWN] button

3. System info

Temperature

press ENTER button when show the Temperature menu, then it

will show the temperature of the fixture

4. Color menu

press ENTER button when show the Color menu, press Enter

button to select the color mode, then adjust the color by pressing

[UP] or [DOWN] button

5. Auto test

press ENTER button when show the auto test menu, select test

mode by pressing [UP] or [DOWN] button

DMX functions and values

3-Channel Mode

Ch.

Function

Values

Description

Coarse Tilt

000 - 255

0-180°

Fine Tilt

000 - 255

0-2°

Strobe

000 - 010

No function

011 - 255

From slow to fast

12-Channel Mode

Ch.

Function

Values

Description

Coarse Tilt

000 - 255

0-180°

Fine Tilt

000 - 255

0-2°

Master

Dimmer

000 - 255

0 - 100%

RGB

Intensity

000 - 255

0 - 100%

All Red LED

000 - 255

0 - 100%

All Green LED

000 - 255

0 - 100%

All Blue LED

000 - 255

0 - 100%

Duration RGB

000 - 255

0 - 100%

Strobe RGB

000-010

0 - 100%

011-255

0 - 100%

All White

LED

000 - 255

0 - 100%

Duration W

000 - 255

0 - 100%

Strobe W

000 - 010

No function

011 - 255

From slow to fast

16-Channel Mode

Ch.

Function

Values

Description

Coarse Tilt

000 - 255

0-180°

Fine Tilt

000 - 255

0-2°

Master

Dimmer

000 - 255

0 - 100%

Master

Dimmer fine

000 - 255

0 - 100%

RGB

Intensity

000 - 255

0 - 100%

All Red LED

000 - 255

0 - 100%

All Green LED

000 - 255

0 - 100%

All Blue LED

000 - 255

0 - 100%

Duration RGB

000 - 255

0 - 100%

Strobe RGB

000-010

0 - 100%

All White

LED

011-255

0 - 100%

000 - 255

0 - 100%

Duration W

000 - 255

0 - 100%

Strobe W

000 - 010

No function

011 - 255

From slow to fast

Macro

000-035

No function

036-071

Effect 1

072-107

Effect 2

108-143

Effect 3

144 - 215

Effect 4

216 - 255

Effect 5

Flow Effect

0 - 50

No function

51 - 101

Effect 1

102 - 152

Effect 2

153 - 203

Effect 3

204 - 254

Effect 4

255

Effect 5

speed

000 - 254

Fast to slow

255

Tungsten effect

28-Channel Mode

Ch.

Function

Values

Description

Coarse Tilt

000 - 255

0-180°

Fine Tilt

000 - 255

0-2°

Master

Dimmer

000 - 255

0 - 100%

Master

Dimmer fine

000 - 255

0 - 100%

RGB

Intensity

000 - 255

0 - 100%

All Red LED

000 - 255

0 - 100%

All Green LED

000 - 255

0 - 100%

All Blue LED

000 - 255

0 - 100%

Duration RGB

000 - 255

0 - 100%

Indice

Altri manuali Squareled Attrezzatura per DJ

Squareled

Squareled LTH PRO.fessional Manuale utente

Squareled

Squareled Dancefloor Manuale utente

Squareled

Squareled LUMINO 200W-RGBW Manuale utente

Squareled

Squareled Splash 200W Fresnel IP65 Manuale utente

Squareled

Squareled tricolor ip65 Manuale utente

Squareled

Squareled Hi-Precision 300W LED Profiler MK2 fixed Manuale utente

Squareled

Squareled PQ818 Manuale utente

Squareled

Squareled SquareLED Zyclone 300W RGBAL Manuale utente

Squareled

Squareled LED MATRIX 16X30W COB BLINDER Manuale utente

Squareled

Squareled STORM 5 Manuale utente

Squareled

Squareled Hi-Precision 500W RGBAL Zoom Manuale utente

Squareled

Squareled Vintage PAR Senior LED Manuale utente

Squareled

Squareled Bajazzo Guida rapida

Squareled

Squareled EXPO Manuale utente

Squareled

Squareled Funky Bee Manuale utente

Squareled

Squareled Hi-Precision 500W RGBAL Zoom Manuale utente

Squareled

Squareled Aura Bar & Matrix Beam Light 100 Manuale utente

Squareled

Squareled PQ1036 Manuale utente

Squareled

Squareled Color Designer 18x12W RGBAW+UV Manuale utente

Squareled

Squareled Ventura 6x25W RGBAW Matrix Bar Manuale utente

Squareled

Squareled SPIRIT Manuale utente

Squareled

Squareled LED CYC LIGHT 48x3W RGBA Manuale utente

Squareled

Squareled Edgy Manuale utente

Squareled

Squareled MRX Bar MKII Manuale utente

Manuali Attrezzatura per DJ popolari di altre marche

ALPHA LITE

ALPHA LITE ALPHA 1500 Manuale del proprietario

Chauvet

Chauvet OVATION E-930VW Manuale utente

Zumtobel

Zumtobel APHRODITE Home Manuale utente

Snow Masters

Snow Masters Zig Oscillator Manuale utente

EuroLite

EuroLite 50530554 Manuale utente

Beamz

Beamz BUV243 Manuale utente

thomann

thomann Stairville DJ Lase 40-G MK-III Manuale utente

Eagletone

Eagletone 6 Eyes Flower Manuale utente

EuroLite

EuroLite FLD-1508 Manuale utente

Technical Pro

Technical Pro LG8xSEA Manuale utente

JB Systems

JB Systems Lounge Laser DMX Manuale utente

Lightmaxx

Lightmaxx Vega Halo 90 Manuale utente

Elation

Elation FUZE WASH Z350 Manuale utente

Maverick

Maverick MK3 WASH Manuale utente

Infinity

Infinity TF-260C7 Fresnel Manuale utente

Chauvet

Chauvet EVE E-50Z Manuale utente

Eliminator Lighting

Eliminator Lighting E 138 Manuale utente

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manuale utente