Stack-On QAS-1512 Manuale utente

Instructions

QAS-1512

QAS-1545

IMPORTANT

GETTING STARTED

CONTROL FEATURES

1. Key lock

2. Combination buttons

3. Reset button (inside safe)

4. Battery Compartment (inside safe)

Record the serial number from the tag on the door front.

Record your combination.

Keep keys and combination in a secure place away

from children.

DO NOT STORE YOUR KEYS OR

COMBINATION INSIDE THE SAFE.

When you rst receive your safe you will need to

open the door with the key in order to install the

baeries. Baeries are included and are located

inside the safe.

NOTE: is key has also been provided incase you

lose or forget your security code or the baeries run

low. If you lose your key, you may purchase a

replacement key by referencing the serial number

located on the front of the door. See section

regarding replacement keys for further information.

To open the safe, insert key into lock and turn

clockwise until the door automatically opens.

NOTE: You must turn the key back to the locked

position before you are able to close and lock the

door.

Tools Required:

Drill

Flat Head Screwdriver

10 mm Wrench

3/16” (5 mm) drill bit for drilling into wood

Hardware Included:

(4) M6 x 20 mm (3/4” long) Screws

(4) Washers

INSTALLING THE BATTERIES

NOTE: Do not mix old and new baeries. Do not

mix alkaline, standard or rechargeable baeries.

If your safe includes a shelf, remove it for beer

access to the baery compartment. Push the baery

cover locking tab with a screwdriver to release the

cover. Install the (4) AA alkaline baeries as shown.

Replace the cover by inserting the rear tabs in the

slots and snapping the cover in place.

NOTE: If the baeries are low the combination

buons will ash red when pushed. Replace with

4 new AA alkaline baeries as shown.

• For security you must program your own

combination aer opening the safe.

• Record your new combination on this form

If you write down your combination you must

keep this information in a secure place, away

from children, not inside the safe.

PROGRAMMING YOUR OWN

ELECTRONIC COMBINATION

Press the Reset Buon (3) located inside the safe.

Two “beeps” will sound (if the sound is turned

on) and all 3 buons will ash blue twice. You

will have 5 seconds to begin entering your

combination or you will have to start over.

Example: (RIGHT) - (LEFT) - (CENTER) -

(LEFT) - (RIGHT)

For each combination entry a “beep” will sound

(if the sound is turned on) and all the buons

will light up green. If you delay more than 5

seconds between entries you will have to start

over from step 1. Aer you have nished

entering your combination, you will have 5

seconds to press the Reset Buon to record

your new combination or you will have to start

over from step 1.

Enter your own 3-8 buon combination by

pressing any combination of the 3 buons.

3. When you press the Reset Buon to record

your new combination, there will be two

“beeps” (if the sound is turned on) and all 3

keys ash blue twice, indicating your new

combination has been recorded.

Reset Button

OPENING THE SAFE USING

YOUR COMBINATION

Enter your combination using the buons. e

buons will light up green and there will be one

“beep” for every entry (if the sound is turned on). If

you entered the correct combination, the buons will

ash green and the door will open. If the combination

is incorrect the safe will beep 3 times (if the sound is

turned on) and the red light will ash 3 times.

NOTE: You will have 2 seconds between individual

entries before the safe assumes you have entered your

complete combination.

To close the safe, push the door closed until locked.

TURNING THE KEYPAD SOUND

OFF/ON

You can turn o the "Beep" sound of the keypad by

pressing all the buons at the same time and

holding for 3 seconds until the green light ashes.

To turn the "Beep" sound on, press the le and

middle buon at the same time and hold for 3

seconds until the green light ashes.

If an incorrect security code is entered 3 times the

safe will beep 5 times (if the sound is turned on) and

the red light will ash 5 times resulting in the safe

being automatically locked out for 60 seconds before

you can try your code again. e safe will beep one

times (if the sound is turned on) and the green light

will ash once when the lockout period is over.

If an incorrect security code is entered 1 additional

time the safe will beep 5 times (if the sound is turned

on) and the red light will ash 5 times resulting in the

safe being automatically locked out for 5 minutes

before the code can be tried again. e safe will beep

one times (if the sound is turned on) and the green

light will ash once when the lockout period is over.

Your safe comes with the "Beep" sound turned on.

e safe must be mounted to a shelf

. For optimal

safety and security, the safe should be installed in

an isolated, dry and secure area.

SECURING THE SAFE

SELECTING A LOCATION

NOTE: is safe must be mounted to a shelf.

Failure to do so will compromise the safety and

security of the safe.

NOTE ON LOCKING THE SAFE: e safe

needs to be in an upright position, as shown in

gure 1, for the locking mechanism to function

properly. Failure to mount the safe in the

corrrect upright position will compromise the

safety and security of the safe.

Secure the safe to a shelf using the predrilled

mounting holes in the safe and hardware provided.

Place the safe in the desired location and mark the

mounting holes to be used with a pencil. Move the

safe and drill the pilot holes for the screws. For

mounting to a shelf, drill 3/16” diameter pilot holes

and aach the safe using the 3/4“ screws and

washers. (Figure 2)

Figure 1

QAS-1545

QAS-1512

Figure 2

THE SAFE SHOULD ALWAYS BE KEPT

OUT OF THE REACH OF CHILDREN.

Altri manuali per QAS-1512

Questo manuale è adatto per i seguenti modelli

Altri manuali Stack-On Sicuro

Stack-On

Stack-On W-22-BH-E-S Manuale utente

Stack-On

Stack-On QAS-450-B Manuale utente

Stack-On

Stack-On PWS-1855-E Manuale utente

Stack-On

Stack-On SECURITY PLUS Manuale utente

Stack-On

Stack-On PDS-1500 Manuale utente

Stack-On

Stack-On TDS-42-SG-E-S Manuale utente

Stack-On

Stack-On TD-040-GP-E Manuale utente

Stack-On

Stack-On PWS-15522-B Manuale utente

Stack-On

Stack-On SECURITY PLUS GC-908-5 Manuale utente

Stack-On

Stack-On PS-1514 Manuale utente

Stack-On

Stack-On TD14-22-GP-C-S Manuale utente

Stack-On

Stack-On PC-1702-RFID Manuale utente

Stack-On

Stack-On QAS-1514-B Manuale utente

Stack-On

Stack-On PFWS-080-B-D-E Manuale utente

Stack-On

Stack-On QAS-1304-12 Manuale utente

Stack-On

Stack-On SS-16-MB-B Manuale utente

Stack-On

Stack-On PDS-1500-B Manuale utente

Stack-On

Stack-On PS-5-B-12 Manuale utente

Stack-On

Stack-On SS-22-MB-C Manuale utente

Stack-On

Stack-On QAS-1510-B Manuale utente

Stack-On

Stack-On PC-650 Manuale utente

Stack-On

Stack-On E-24-MG-C-S Manuale utente

Stack-On

Stack-On QAS-1512 Manuale utente

Stack-On

Stack-On SS-16-MB-B Manuale utente

Manuali Sicuro popolari di altre marche

Squire

Squire Stronghold Keysafe Manuale utente

Phoenix

Phoenix FS0352C Scheda informativa del prodotto

Phoenix

Phoenix KS0030E Series Manuale utente

Vaultek

Vaultek 10 Series Scheda tecnica

Arregui

Arregui CLASS Manuale utente

Beaumont

Beaumont SMART KEYBOX Manuale utente

Honeywell

Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Manuale utente

Hornady

Hornady SnapSafe Trunk Safe II Manuale utente

SPORTS AFIELD

SPORTS AFIELD SA-HD5-BIO Manuale utente

Honeywell

Honeywell 5912 Manuale utente

Phoenix

Phoenix FS1280F Manuale utente

Phoenix

Phoenix SS0992K Scheda informativa del prodotto

Technomax

Technomax Trony Series Manuale

SPORTS AFIELD

SPORTS AFIELD INSTINCT BIOMETRIC Series Manuale utente

RICHTER CZECH

RICHTER CZECH LA Manuale operativo

Olymp

Olymp GOsafe 110 Manuale utente

Phoenix

Phoenix SS0100E Scheda informativa del prodotto

Clarke

Clarke Strong-Arm CS1000K Manuale di istruzioni