1) Unscrew Fluid Reservoir
Cap and fill reservoir with
appropriate chemical fluid up
to a maximum 4.5 litres.
➢ if the uid that you will be
using requires dilution then
predilute in an appropriate
mixing container such as
large jug before pouring into
the uid reservoir.
2) Replace Fluid Reservoir Cap
tightly, ensuring it is completely
air tight.
3) Connect power supply to the
supplied plug-in RCD (Residual
Current Device) and plug the
RCD into a wall plug socket.
Press reset button on the RCD to
ensure it is live.
4) Ensure the Flow Control
Screw is opened at least 3
full turns from the closed
position (anticlockwise will
increase output fog volume and
clockwise will reduce it).
5) Hold machine level and press
the On/O Switch to the On
position.
6) Re-adjust Flow Control Screw
to achieve the required fog
output ow
7) Spray in a smooth motion,
not aggressively rocking the
machine or tilting the reservoir
backwards (as that will cause
intermittent supply of uid to
the pick-up pipe in the Fluid
Reservoir).
8) To alter angle of spray
upwards or downwards simply
change the angle of the Top
Section using the Spray Angle
Pivot.
9) When machine is operating
keep the Fluid Reservoir tilted
slightly downwards towards
the front of the machine to
ensure the suction pick up
tube located beneath the Flow
Control Screw is continuously
fed with uid.
10) Cordon off the sprayed
area for at least 15-20 minutes
to allow disinfection to be
completed.
11) For common high touch
areas such as door handles
and work surfaces continue to
frequently manually disinfect
with spray & wipe cleaning
techniques in addition to
fogging as per normal or
enhanced cleaning routines.
Instructions for Use Refer to Figure 1 as required
3
