What Is DAB+?
This in-car receiver receives DAB+ signal.
DAB+ essentially uses the same technology as DAB, however the main difference is
that DAB+ makes more efficient use of the available bandwidth so that it can send
up to three times more data than a standard DAB signal. This allows for a better
audio quality and also allows for more reliable reception.
Set Up & Installation
To operate this DAB adaptor, you will need to securely fit the antenna
onto your vehicle’s windscreen, and then connect the antenna to the DAB
adaptor via anthenna jack. Please follow the instructions below:
1. Remove the product from its packaging and dispose of the packaging
in the correct manner.
2. Open the driver side door of your vehicle and carefully remove the
interior panel from the right-hand frame of the windscreen. This
will reveal a metal pillar. Important: Please refer to your vehicle’s
handbook for safe and proper removal of the internal panel.
3. With the antenna, carefully remove the protective paper from both
the clear adhesive film and the black adhesive film. Discard both
protective papers in the correct manner.
4. Then attach the black adhesive film to the metal pillar and the
transparent film onto the windscreen. Please ensure that you attach
the antenna properly so that you can reinstall the panel later.
5. Thread the antenna’s wiring along the metal pillar, towards the bottom
and allow the connector-end of the wire to rest on your vehicle’s
dashboard. Ensure you have enough wire to connect the DAB adaptor
when mounted on either the dashboard or air vent mount.
Important: Be careful not to overstretch the wire when doing so.
6. Reinstall the panel back. Important: Please refer to the vehicle
handbook for safe and proper installation.
7. Mount the antenna to either the air vent or dashboard (see Mounting
The DAB adaptor).
8. Connect the antenna to the DAB adaptor.
9. Plug in the DAB adaptor to your vehicle’s 12V socket and switch on
your vehicle to turn on the DAB adaptor.
see diagram overleaf
