34
FRONT VIEW
1. RS-232 Port
2. IR IN
3. Display LED (Select / Link)
4. Select Key
REAR VIEW
1. POWER JACK 12V DC
2. HDMI OUTPUT
3. HDMI INPUT
MODE Select
There is not connector to any HDMI IN/OUT cable while pressing select key1 and
key2 into mode select.
Mode Features LED Display
1 (default) Manual LED1 Flashes
2 Auto skip All LED Flashes
3 Auto sensing Marquee
4 Port 1 priority LED1 flash, and then after LED2~8 flash
RS232 Console Protocol
Baud Rate: 115200, n parity bit, 8 data bits, 1 stop bit
Ascii Base
Execute Command by '\r' (carriage return)
Command List
-----------------------------------------------------------
Command Description
-----------------------------------------------------------
help : Display help information
reset : Reset the device
info : Display device information
status : Display device status
r : Set the routing status
rs : Display the routing status
save : Save the current settings to Preset
load : Load settings from Preset
edid : Select input EDID mode
default : Reset to factory default settings
For more information, type '/h' or '?' after each commands.
Installation
1. Connect the HDMI cable with the BD player or PC and the <IN> port.
2. Connect the HDMI cable with the UHDTV and the <OUT> ports.
3. Connect the power cord and turn on theAH series .
4. Turn on the BD player or PC and UHDTV.
