TEC TEC B-210 SERIES Manuale utente

TEC Portable Printer

B-210 SERIES

Owner’s ManualDocument No. EM1-33043D

TOSHIBA TEC CORPORATION

DECLARATION OF

CONFORMITY

Manufacturer

Address

Product Name

model

options

Safety

EMC

: TEC Corporation

: 570 Ohi to. Ohito-Cho.

Tagata-Gun, Shizuoka-Ken,

41 D-23 Japan

declares that following

product

: Bar Code Printer

: B-210 Series

: All

Conforms to the following

Product Specifications

: EN 60 950

: EN 56 022

IEC 801 -2

IEC 801-3

Supplementary Information

The product herewith complies with the

requirements of the Low Voltage Directive 73/

23/EEC. and the EMC directive 89/336/EEC.

1) The product was tested in a typical set up

TEC personnel advocated.

2) The following technical documentation has

been filed for review.

• Factory Inspection Certificate by TUV

Rheinland

• Owner's Manual

• Schematic

• Certificates and Test Reports

EM1-33043A

TABLE OF CONTENTS

Page

1. INTRODUCTION ........................1-1

1.1 APPLICABLE MODEL ...........1-10

1.2 ACCESSORIES .....................1-11

2. SPECIFICATIONS ......................2-1

2.1 PRINTER ..............................2-1

2.2 SERIAL INTERFACE

(RS-232C) ...................................2-2

2.3 RADIO INTERFACE .............2-2

2.4 IrDA INTERFACE...................2-3

2.5 MEDIA ..................................2-4

3. APPEARANCE ............................3-1

3.1 FRONT/REAR VIEW .............3-1

3.2 OPERATION PANEL .............3-2

4. INSTALLING THE PRINTER ......4-1

4.1 LOADING THE BATTERY.....4-1

4.2 INSTALLING THE

MEDIA GUIDE ......................4-3

5. LOADING THE MEDIA ................5-1

6. SECURING THE PRINTER

TO YOUR WAIST ........................6-1

7. ISSUING THE MEDIA ..................7-1

8. CARE/HANDLING

OF THE MEDIA ...........................8-1

Page

9. GENERAL MAINTENANCE ..........9-1

9.1 CLEANING .............................9-1

9.2 COVERS AND

OPERATION PANEL .............. 9-3

9.3 REMOVING JAMMED

MEDIA .................................... 9-4

10. TROUBLESHOOTING ................10-1

EM1-33043A

CAUTION:

1. This manual may not be copied in whole or in

part without

the

prior written permission of

TEC.

2. The contents of this manual may be changed

without notification.

3. Please refer to your local Authorized Service

representative with regard to any queries you

may have in this manual.

by TEC CORPORATION

570 Ohito. Ohito-cho. Tagata-gun. Shizuoka-ken. JAPAN

1- 1

EM1-33043D

1. INTRODUCTION

Thank you for purchasing the TEC B-210

series portable printer.

The B-210 printer displays its high

performance with extraordinarily high

speedprintingupto50.8mm/sec.Ithasa

considerablycompactandlightbodyof88

mminheight,128mminwidthand50mm

in depth, weighing about 460 g.

As data communication method, minute

radio communication (for GH11 and

GH12 models) or IrDA (GH24 model),

which requires no cable for data

transmission between a handy terminal

and the printer, is adopted.

Owingtoalowpowerconsumptiondesign

anduseof a chargeable lithium battery as

a power source, this printer can issue 300

pieces of 40-mm pitch labels with a fully-

charged battery.

Loading a label roll is very simple; just put

a label roll into the printer and close the

mediacover. Abeltholderprovidedonthe

rearoftheprinterenablestheprintertobe

heldhands-freeatyourwaistforimproved

productivity.

This manual contains general set-up and

maintenance information and should be

read carefully to help gain maximum

performanceandlifefromyourprinter. For

most queries please refer to this manual

and keep it safe for future reference.

1- 2

EM1-33043D

1. INTRODUCTION

FCC Notice

This equipment has been tested and

found to comply with the limits for a

Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are

designed to provide reasonable

protection against harmful interference

in a residential installation. This

equipment generates, uses, and can

radiate radio frequency energy and, if

not installed and used in accordance

withtheinstructions,maycauseharmful

interference to radio communications.

However, there is no guarantee that

interferencewillnotoccurinaparticular

installation. Ifthisequipmentdoescause

harmfulinterferencetoradioortelevision

reception, which can be determined by

turning the equipment off and on, the

user is encouraged to try to correct the

interference by one or more of the

following measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet

onacircuitdifferentfromthattowhich

the receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

1. INTRODUCTION

1- 3

EM1-33043D

1. INTRODUCTION

Changes or modifications not expressly

approvedbymanufacturerforcompliance

could void the user's authority to operate

the equipment.

CAUTION

To avoid injury, be careful not to catch or

jam your fingers while opening or closing

the cover.

CAUTION

Donottouchmovingparts. Toreducethe

riskthatfingers,jewelry,clothing,etc.,be

drawn into the moving parts, push the

switch in the "O" position to stop

movement.

Safety Summary

Personalsafetyinhandlingormaintaining

the equipment is extremely important.

Warnings and Cautions necessary for

safehandlingareincludedinthismanual.

All warnings and cautions contained in

this manual and written inside or outside

of the printer should be read and

understoodbeforehandlingormaintaining

the equipment.

Do not attempt to effect repairs to this

equipment. If a fault occurs that cannot

be rectified using the procedures

described in this manual, turn off the

power, then contact your authorised

TOSHIBA TEC representative for

assistance.

1- 4

EM1-33043D

1. INTRODUCTION

Safety Precautions

This Owner's Manual and the products

(machines) which you have purchased

contain indications which should be

observed in order to use the machines

safely and prevent harm to yourself and

others and damage to property. The

meanings of these indications and

symbols are given below.

Read these indications and become

familiarwiththeircontentsbeforereading

this Owner's Manual.

This indicates that there is the risk

of death or serious injury if the

machines are improperly handled

contrary to this indication.

WARNING

•If water or any other liquid enters the

machine, turn off the power.

Continuous use of the machine under

such conditions may cause fire or

electric shock.

•If the enclosure is damaged when

dropped or subject to shock, turn off

the power. Continuous use of the

machine under such conditions may

cause fire or electric shock.

•Avoid continuous exposure to direct

sunlight or high temperature as this

may cause fire.

•Do not remove covers or modify the

machine by yourself. Doing so may

cause fire or electric shock.

1- 5

EM1-33043D

1. INTRODUCTION

•Avoid water, operation with wet hands

or cleaning with a moistened cloth.

Failure to do this may cause fire or

electric shock.

•Do not wipe the machine with a cloth

moistenedwiththinnerorothervolatile

solventasthismaycausefireorelectric

shock.

•Usethe specified batteryonly. Failure

to do this may cause fire or electric

shock.

•Danger of explosion if the battery is

incorrectly replaced. Replace the

battery only with 'TOSHIBA TEC

Corporation,BatteryPackTypeB-213-

BT, 7.2 V 1350 mAh Li-ion'.

Discard used batteries according to

the manufacturer's instruction.

•ATTENTION:

II ya denger d'explosion s'il ya

remplacementincorrectdelabatterrie.

Remplacer uniquement avec une

batterie du même type ou d'un type

équivalent recommandé par le

constructeur.

Mettre au rebut les batteries usagées

conformément aux instructions du

fabricant.

•Do not disassemble and modify the

batterybecauseithasaprotectionunit

init. Doingsomaybreaktheprotection

unit, causing the battery to heat up,

burst or burn.

1- 6

EM1-33043D

1. INTRODUCTION

•Ifthebatterygetswet,dryitcompletely.

Using a wet battery may cause fire or

electric shock.

•Be aware of the following precautions

when using batteries. Otherwise they

could heat up, burst or burn.

■Do not throw the battery into fire or

heat it with a microwave or oven,

etc.

■Do not load the battery with the

electrodes reversed.

■Do not connect the electrodes with

metal objects like wire. Do not

carryorstorethebatteryalongwith

metal objects such as necklaces,

hairpins, etc.

■Donotstickaneedleinto,hammer,

step on, or drop the battery.

■Do not solder the battery.

■Do not leave the battery where the

temperature is more than 60°

centigrade, such as inside a car or

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali TEC Stampante

Manuali Stampante popolari di altre marche

Lexmark

Lexmark 1400 Series Manuale

Canon

Canon i70 Series Manuale utente

Evolis

Evolis Elypso Manuale utente

Kyocera

Kyocera FS-9530DN Manuale utente

Canon

Canon LASER SHOT LBP-1210 Manuale utente

Samsung

Samsung BIXOLON SRP-350plusF Manuale utente

Canon

Canon PIXMA PRO-1 Series Manuale utente

Canon

Canon PIXMA G3560 Guida all'installazione

Dell

Dell Color Laser Printer 2130cn Manuale utente

Tektronix

Tektronix Phaser 840 Manuale utente

Epson

Epson ET-7750 Istruzioni operative

Canon

Canon CLBR 460ps Manuale utente

Eltron

Eltron P210 Guide Manuale utente

Ricoh

Ricoh MD-P1 Manuale utente

Epson

Epson SC-F7100 series Manuale utente

Epson

Epson Stylus C40UX Manuale utente

Canon

Canon imagePASS-A2 Manuale utente

Canon

Canon S820D Manuale utente