Sirio HH Compact
Instruction and maintenance manual
Instruction n° 207 - Rev. 4 datel 19/10/2017
Copyright © 2017TecmecS.r.l. Translated from the ORIGINAL instructions
3 SAFETY
3.1 Safety norms
The products of the series HH Compact must be included in the assessment of the corporate risk, and
requires compliance with applicable laws regarding safety at work .
To ensure the highest possible degree of safety, for the correct use of the equipment, all measure deemed
necessary have been adopted, during the phase of the desing, construction, testing and installation.
For a proper use, the dispenser have to be used by trained personnel, in order to avoid
accidents or injury to person or things.
The used components is in accordance with the applicable standards.
The dispenser SHC Compact must be located in a special tank/container, suitable to contain any accidental
products leaks.
3.2 Electrical power supply
Determined the installation area the following prerequisites have to be implemented:
The main power supply have to be provided through an electrical panel, placed on the wall near to the
dispenser.
The maximun expected power is 0.2Kw. The section of each conductor must be a minimum of 1,5 mm².
The main power supply line must be fitted with an efficient ground connection, and complies with all the
requirements in force.
The electrical power supply panel must be composed of a differential switch (IΔn=0,03A) with voltage
and phase compatible with the agitation motor (single phase).
To ensure a complete safe operation for the operator and the equipment, it's very important using during
the assembly of the electrical panel the above mentioned type of switch, due to the fact that the switch will
have a protective function against possible direct or accidentals voltage hazard down to ground .
It's important to make the necessary assessment of the site, and follow the requiring and characteristic rules
of the electrical system, to ensure that they are not a cause of accidents or injuries.
To avoid that the equipment have instability issues, it's necessary to verify the perfect leveling of the feets
loceded in the bottom part of the structure as per the assembly instructions.
