teko Astra-531 PIR Istruzioni per l'installazione
Astra-531 Ver.PIR
(Surface Lens)
Optic-Electronic PIR Motion
Detector
User Instruction*
Sales:
Controlex GmbH
Philosophenweg 31-33
47051 Duisburg,Germany
+49 (0) 203/393 91 188
info@controlex.eu
www.controlex.eu
Warranty service and
technical support:
TEKO-TD
Prospekt Pobedy str. 19
420138 Kazan, Russia
+7(843) 261-55-75
www.teko.biz
Made in Russia
Rev. 531-ikv1_0_instr_EN
1 FUNCTION
Detector is intended to detect unauthorized
access into closed protected area, and to
generate an alarm notification by opening of
signaling relay contacts.
2 DETECTION ZONE
3 SPECIFICATIONS
Range of detected
moving speed, m/s.................from 0,3 up to 3,0
Power supply voltage, V.............from 8 up to 15
Current consumption, mA, max......................18
Overall dimensions, mm.....................62×37×29
Operating Conditions
Temperature range, °С..............от - 20 до + 50
Relative air humidity, %...........up to 95 at + 35 °С
Withoutmoisturecondensation
4 DELIVERY SET
Delivery set contains holders and fasteners
(bracket - 1pcs., dowel –2 pcs., screw –2
pcs.), jumper –2 pcs.
5 OPERATING MODE
Operating mode
Plug
name
Jumper
position
High detectability
of PIR-channel
Normal
detectability
of PIR-channel
PIR
“Alarm memory”
ON
“Alarm memory”
OFF
Mem
TEST-pass
-
See par. 9
6 INSTALLATION LOCATION
1) Recommended installation height is 5 m max.
2) Installation on ceiling, on a wall, in window
openings and between window frames is al-
lowed.
3) Alarm loop and power supply wires should
be located far from power cables.
To eliminate false alarm hazards
It is recommended to close all doors, air-vents,
switch off fans, air-conditioners and other
sources of intense air flows in the room during
protection period.
Not recommended installation locations
7 INSTALLATION PROCEDURE
1) Remove cover
2) Remove PCB
3a) Installation on the
wall
3b) Installation using
bracket
Detector base should be positioned strictly
as per figure!
4) Replace PCB and
perform wiring
(see par.8)
5) Perform TEST-pass
(see par.9)
8 WIRING
Perform wiring to detector`s terminals in
accordance with control panel operating
manual.
RELAY –terminals for detector connection to
alarm loop;
TMP –detector tampering control terminals;
GND, +12V –power supply terminals.
9 TEST-PASS
1) Remove jumpers from PIR and Mem plugs.
2) Power detector ON. LED starts flash during
60 sec.
3) Close detector.
4) To detect sensitive zones carry out TEST-
pass in the secured zone with the speed of 0,3
and 3 m/s.
On detection (indicator is lighted for 2s) one
should stop, mark this position, then make step
back and continue moving. Repeat TEST-pass
inversely.
10 WARRANTY
The operation warranty period is 5 years from the date
of operation start-up but no longer than 5 years 6
months from the date of manufacturing subject to the
requirements of Operating Manual.
*For more detailed information refer to detector
Operating Manual available for free from
www.controlex.eu.
Hooks
Altri manuali teko Sensore di sicurezza
teko
teko Astra-431 ver. RF Manuale utente
teko
teko Astra-7 ver.A Manuale utente
teko
teko Astra-5131 Manuale utente
teko
teko Astra-516 Manuale utente
teko
teko Astra-517 ver.P Manuale utente
teko
teko Astra-612 Manuale utente
teko
teko Astra-621 Manuale utente
teko
teko Astra-431 Manuale utente
teko
teko Astra-9 Istruzioni per l'installazione
teko
teko Astra-5 Ver.A Manuale utente
teko
teko Astra-3731 Manuale utente
teko
teko Astra-621 RF Manuale utente
teko
teko Astra-8 Manuale utente
teko
teko Astra-43A Manuale utente
teko
teko Astra-3321 Manuale utente
teko
teko Astra-621 Manuale utente
teko
teko Astra-GB Istruzioni per l'installazione
teko
teko Astra-3221 Manuale utente
teko
teko Astra-5131 Manuale utente
teko
teko Astra-R TRC Manuale utente
