teko Astra-7 ver.A Manuale utente
Astra-7 ver.A
(Volumetric Lens)
Optic-Electronic PIR Motion
Detector
User Guide
Manufacturer:
ZAO NTC TEKO
420108 Kazan, Russia
Gafuri 71
+7 843 528-03-69
www.teko.biz
Made in Russia
Rev. 7-av1_5_instr_en
1 FUNCTION
Detector is intended to detect unauthorized
access into closed protected area and generate
an alarm notification by opening relay contacts.
2 DETECTION ZONE
3 SPECIFICATION
Range of detectable
moving speed, m/sec.............from 0.3 up to 3.0
Power supply voltage, V.............from 8 up to 15
Current consumption, mA, max......................15
Overall dimensions, mm..................diameter 91
height 31
Operating Conditions
Temperature range, °С........ from - 30 up to +50
Relative air humidity, % .......... up to 98 at +25 °С
Withoutmoisture condensation
4 DELIVERY SET
Delivery set includes: dowel –2 pcs., screw –2
pcs., user guide –1 pcs., label –2 pcs.
5 MODES OF OPERATION
Plug
Jumper
position
High detectability
Normal
detectability
Mode
Indication ON
Indication OFF
Ind
“Alarm memory”
ON
“Alarm memory”
OFF
Mem
TEST-pass
Ind
See sec. 9
6 INSTALLATION PLACE
1) Recommended installation height is 2.4-3.6 m.
2) Detector should be installed on the ceiling
(or any other horizontal surface) horizontally.
3) Alarm loop and power supply wires should
be located far from power cables.
To eliminate false alarm hazards
It is recommended to close all doors, air-vents,
switch off fans, air-conditioners and other
sources of intense air flows in the room during
protection period.
Not recommended installation places
7 INSTALLATION PROCEDURE
1) Remove
cover
2) Remove
PCB
3) Install base
on the
ceiling
4) Install PCB
and perform
wiring (see
sec.8)
5) Perform TEST-pass (see sec.9)
8 WIRING
Perform wiring to detector`s terminals in
accordance with control panel operating manual.
TMP –detector tampering control terminals;
RELAY –terminals for detector connection to
alarm loop;
+12V, GND –power supply terminals.
9 TEST-PASS
1) Remove jumper from Mem plug, install
jumpers on Ind and Mode plugs.
2) Power detector ON. LED starts flash during
60 sec.
3) During this time
4) Close detector.
5) To detect sensitive
zones carry out
TEST-pass in the
secured zone with the
speed of 0,3 m/sec.
On detection
(indicator is lighted
for 2sec) one should
stop, mark this
position, then make
step back and continue moving.
Repeat TEST-pass inversely.
10 WARRANTY
The operation warranty period is 5 years from
the date of operation start-up but no longer than
5 years 6 months from the date of manufactur-
ing subject to the requirements of Operating
Manual.
Altri manuali teko Sensore di sicurezza
teko
teko Astra-8 Manuale utente
teko
teko Astra-5131 Manuale utente
teko
teko Astra-642 Manuale utente
teko
teko Astra-551 Manuale utente
teko
teko Astra-43A Manuale utente
teko
teko Astra-R TRC Manuale utente
teko
teko Astra-8 Manuale utente
teko
teko Astra-MA Manuale utente
teko
teko Astra-621 Manuale utente
teko
teko Astra-551 Manuale utente
teko
teko Astra-3731 Manuale utente
teko
teko Astra-6131 Manuale utente
teko
teko Astra-5131 Manuale utente
teko
teko Astra-GB Istruzioni per l'installazione
teko
teko Astra-3321 Manuale utente
teko
teko Astra-515 ver.A Manuale utente
teko
teko Astra-5 ver.A Manuale utente
teko
teko Astra-517 ver.P Manuale utente
teko
teko Astra-Z-3645 Manuale utente
teko
teko Astra-431 Manuale utente
