Configuring the configuration pattern for MIP installation
Aquick configuration process exists to simplifythe installation process for newMIPs. Here a
minimum number of parameters are manuallyconfigured in the MIPand, subsequently,a‘register’
operation is executed using an installer password. The MIPreceives the configuration of the
configuration pattern during this process, where the installer password coincides with that provided.
Belowyou will see aconfiguration pattern displayed with installer password 1111.For further
information on each of these parameters, please see the VisorALARM+ Installation manual.
ARLY-1 Cfg> cfg-pattern 1 default
ARLY-1 Cfg> cfg-pattern 1 instalator-password 1111
ARLY-1 Cfg> cfg-pattern 1 usr-password 1234
ARLY-1 Cfg> cfg-pattern 1 mip-password ZYXW5678
ARLY-1 Cfg> cfg-pattern 1 receiver-password WXYZ4321
ARLY-1 Cfg> cfg-pattern 1 keep-alive-timer 45
ARLY-1 Cfg> cfg-pattern 1 keep-alive-retries 3
ARLY-1 Cfg> cfg-pattern 1 keep-alive-retries-timer 2
ARLY-1 Cfg> cfg-pattern 1 phone-length 9
ARLY-1 Cfg> cfg-pattern 1 alarm-tx-retries 2
ARLY-1 Cfg> cfg-pattern 1 callback-phone 918076565
ARLY-1 Cfg> cfg-pattern 1 bck-receiver-IP 80.26.96.183
ARLY-1 Cfg> cfg-pattern 1 bck-keep-alive-timer 45
ARLY-1 Cfg> cfg-pattern 1 bck-keep-alive-retries 3
ARLY-1 Cfg> cfg-pattern 1 bck-keep-alive-retries-timer 2
Configuring events
ARLY-1 Cfg>exit
Config>event
-- ELS Config --
ELS config> enable trace subsystem ARLY ALL
ELS config>exit
Configuring the speed of the UD communication ports
To set the speed for the UD com1 port use the next command replacing the portSpeed parameter by
the desired port speed.
Config>net serial1/0
MODEMEMU-serial1/0 Cfg>speed portSpeed
MODEMEMU-serial1/0 Cfg>exit
Config>
Toset the speed for the UD com2 port use the next command replacing the portSpeed parameter by
the desired port speed.
Config>net serial1/1
MODEMEMU-serial1/1 Cfg>speed portSpeed
MODEMEMU-serial1/1 Cfg>exit
Config>
Finallysave the configuration and restart in order to activate the newsettings. Ifyou wish to check
the configuration, the “show config”command will displaythe configuration from the menu
where this is located together with all its submenus.
Config> save
Save configuration (Yes/No) [No]? y
OK on Flash (not saved in SmartCard)
Config>[CTRL-P]
*restart
Are you sure to restart the system(Yes/No)? y
*
Restarting. Please wait ................................
