How to Set & Start
Timer
a. Setting- up the time
cycle:
The ODPT
TM
timer is set for 6 hours by
default.
To change the cycle (from 1-8
hours):
1. Switch OFF the
thermometer.
2. Press and hold the SET
button.
3. Continue pressing the SET button, then press the
timer
button once and release
both
buttons.
4.
The interval time value will blink on the
display.
5. Press the
“Timer”
button to scroll through time interval
options.
9
The display will show time values between 1-8
hours
(1, 2, 3, 4, 5, 6, 7, 8) and then back to 1 hour (starting over again).
(See figure
9).
6. Release the
“Timer”
button when the desired value appears on the
display.
Then
press the SET button in order to set the desired
value.
b. Operating the
timer:
1.
To start the timer press and release the “Timer” button. The
timer's
10
display will show "0:00" (See figure 10) . Press again and the timer
will start counting seconds until "0:01" minute and then
minutes.
2.
To reset the timer press and hold the
“Timer” button.
(Press the “Timer” button until display changes to “0:00”).
3.
To start the timer again, press the
“Timer”
button
again.
The count will start
from
“0:00”.
IMPORTANT
NOTES:
•
The ODPT
TM
timer can be used while the thermometer is on or
off.
•
The ODPT
TM
timer continues to count the time elapsed even if the thermometer
is
turned
off.
•
It is not possible to turn on the timer when conducting temperature
measurement.
Temperatures can be taken while the timer is
running.
•
If the ODPT
TM
timer is stopped mid-cycle, cycle must be reset by pressing and
holding the timer button for 3 seconds. To resume the timer press the
timer
button
again.
•
When the time cycle has ended the thermometer will beep.
The display will
blink
the pre-set time cycle for 60
seconds.
For example, if the timer was set to 6 hours, the image “6:00” will blink on
the
display. 5
