TERK Technologies VS4-MOD+ Manuale utente
SPECIFICATIONS:
RF Output Channels: 3 or 4
Video Carrier Output Level: 69dB uV
Impedance: 75 ohms
Video Input Impedance: 75 ohms
Audio Input Impedance: 13 +- 3 K ohms
Installation Instructions:
For a TV without color-coded
A/V inputs:
1. Connect a coax cable from the
output of your cable box/wall jack
or antenna to the “ANT IN” input
on the VS4-MOD+.
2. Connect a standard, color-coded
A/V (or S-Video) cable from a video
component to the “Input 1” on the
rear of the VS4-MOD+.
You can connect up to 4
components this way.
3. Connect a coax cable from the
VS4-MOD+ “TO TV” output to the
coax input of your TV.
4. Set the “Channel 3-4” switch to
the channel you would like to view
your programming on.
5. Plug the A/C adapter into the
VS4-MOD+ and then into an
electrical outlet.
6. Turn your TV to channel 3-4.
For a TV with color-coded
A/V inputs:
1. See step 1 from above.
2. Connect a standard, color-coded
A/V (or S-Video) cable from a video
component to the “Input 1” on the
rear of the VS4-MOD+.
3. Connect the color-coded A/V (or
S-Video) cables from the VS4-MOD+
“Output” to the color-coded A/V
inputs of your TV.
4. Plug the A/C adapter into the
VS4-MOD+ and then into an
electrical outlet.
5. Change your TV input mode
to “VIDEO”.
75 ohm
RLV
TV
OR
OR
Cable Box Antenna
OUT
IN
(75 ohm Cable)
TERK VS4-MOD+
(Connect up to four
components to VS4-MOD+)
CHANNEL
3 4 ToT V
ant.In
input1
LV
RS
input 2
LV
RS
input 3
LV
RS
input 4
LV
RS
output
LV
RS
9V---
200mA
AUDIO S-VIDEO
RL
Satellite,DVD, VCR,
Game, Camcorder
S-Video hook upA/V cable hook up
OR
VIDEO AUDIO
RL
Typical Install
Cut carefully along dotted line with scissors.
Remote Controlled
VIDEO SWITCH
andCONVERTER
How to use the VS4-MOD+:
1. Press the “Power” button to turn
on the VS4-MOD+.
2. Press the “Select” button on the
front of the VS4-MOD+ to select the
video source you would like to view.
3. Turn the video source on.
For learning remote functions see
instructions on card back:
Altri manuali TERK Technologies Interruttore
