Texas Instruments TD1000 Manuale utente
TDC1000 Ultrasonic “Test Cell” Assembly Instructions
Rev 1.0
Supplies required:
1. CYA glue w/Latex
2. CYA Accelerator
3. Plastic “test cell” container
4. 400 grit sandpaper
5. Alcohol
6. Hot glue gun
7. Ultrasonic transducers w/attached wires
8. Spray duster/ air gun
Assembly Steps:
1. Roughen 1cm square area on lower side of plastic container with sandpaper
2. Degrease with alcohol
3. Dry area with air gun
4. Apply CYA glue to 1cm square area
5. Attach transducer to glue spot with leads out to side of container
6. While applying gentle pressure to transducer to hold it in place apply “CYA Accelerator”
to transducer.
7. Wait approximately 15 sec for glue to cure. Blow off excess Accelerator.
8. Apply alcohol to clean area. Dry area with air gun
9. Apply hot glue around the circumference of the transducer
10. and continue covering transducer until it is completely covered in hotglue
11. Use air to gently cool glue.
Indice
Altri manuali Texas Instruments Attrezzature da laboratorio
Manuali Attrezzature da laboratorio popolari di altre marche
Agilent Technologies
Agilent Technologies 5800 ICP-OES Manuale utente
Endress+Hauser
Endress+Hauser Cleanfit CPA875 Manuale utente
NI
NI PXI-5422 Manuale
Collomix
Collomix Aqix Manuale utente
SPEX SamplePrep
SPEX SamplePrep 6875 Freezer/Mill Series Manuale utente
Ocean Insight
Ocean Insight FLAME-NIR+ Manuale utente
