Third Eye inViewTM Installation Guide and User Manual v181206 8 | Page
you may carefully tilt the helmet receiver unit up or down to separate it from the helmet,
reposition it, or to install it on a passenger helmet with the (supplied) extra Dual-locktm coin.
Installation Tip: The helmet receiver unit has a tested range of approximately 10 feet. If it
seems that you do not have consistent functionality when in a riding position, then the
transceiver unit attached to the motorcycle may be blocked or affected by its location. Try
relocating the transceiver unit or repositioning it to increase antenna gain.
General use and care:
Operation: Third Eye inViewTM was designed as a set and forget device that requires minimal user
intervention. Once connected, a double chirp and vibration will let you know the unit is functioning
properly. When the unit disconnects (or goes back to sleep) the unit will alert you with a single chirp
and vibration. The helmet unit should be visually inspected prior to each ride to insure it is installed
correctly and working properly.
Each time the helmet unit connects to the motorcycle transceiver, the helmet unit will perform an
inversion test to make sure it is installed correctly (and not upside down). If the helmet unit is
installed upside down, it will flash and chirp repeatedly until it is correctly oriented. This test only
occurs once each time it connects to the motorcycle. Note: Be careful not to remove and reinstall the
helmet unit while the motorcycle is running since the test will not be performed until the unit
reconnects to the motorcycle the next time it is started.
Battery Installation: When changing the batteries, please make sure the motorcycle is off and not
connected to the helmet unit. Please be sure the rubber skirt is properly in place to allow the back to
seal against it. While the back is off, avoid exposure to dust, moisture or other contaminants. Do not
overtighten the screws! Just 3 inch-pounds of force (a gentle, finger tight) is necessary to tighten the
back against the skirt gasket.
Performance tip: Third Eye inViewTM was designed for use with LI (lithium-ion) batteries which
offer better power characteristics and, as an added benefit, are lighter weight.
FCC Statement:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
IC Statement:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le onctionnement.
