Press ‘Prog’ and hold for approx. 2 seconds. Whilst holding, the word ‘HOLD’ will appear in
the top left hand corner of the display.
After 2 seconds the display will show:-
Press ‘Adv’ or ‘Bst’ to select the day grouping which requires modifying or a new day
grouping for an additional programme, in which case proceed as in section 8.1.
For modifications press ‘Prog’ repeatedly to arrive at the programme time (flashing)
requiring modification then use ‘Adv’ or ‘Bst’ to make the change. Press ‘Prog’ again
repeatedly to arrive at a further time requiring modification and use ‘Adv’ or ‘Bst’ to make
the change.
Proceed as before for further changes then press ‘Prog’ for 2 seconds to return to
operating mode unless you are at the end of the programme sequence, in which case
press ‘Prog’ briefly.
There is no automatic exit to the operating mode.
The reset button can also be used whenever major changes of programmes are
required.
9. Programming the ON / OFF Times -
FST11A only
The FST11A is similar to the FST17A but only has one day group mode in
programming – Mo Tu We Th Fr Sa Su giving 24 hour operation. Up to 4
programmes can be entered (once only required) in the same way as for the
FST17A (refer to section 8).
MODE
Prog Adv
Time Bst
Mo Tu We Th Fr Sa Su
SET
8.2 Modifying or Adding Programmes
The display will show the correct day and time but the ON / OFF indicator may not
reflect the current programme accurately in which case press the ‘Adv’ button
to correct the indicator.
In the same way as for individual programmes, days or groups of days can be omitted
either by leaving dashes in all the locations for a day or a group of days or by leaving
the programming mode before its completion where all further entries are to be
dashes.
