Page 4 For technical questions, please call 1-888-866-5797. Item 59403
Full Assembly Configuration
1. Attach the four Short Legs (2) to the Tabletop
(1). Screw two Bolts (6) into the outermost
holes on each Short Leg. Secure with
Nuts (7). See Figure A on page 3.
2. Connect Leg Brace (4) to the Long
Legs (3) using the holes in the middle
of the Long Legs (3). See Figure B.
Leg Brace (4)
Long
Leg (3)
Leveling
Foot (5)
Nut (8)
Figure B: Leg Brace (4) Attachment
Note: Use the same height holes on each Long Leg
(3) to make sure the Leg Brace (4) will be level.
3. Place the Tabletop (1) upside down on
a sturdy surface. Set the Leg Assembly
over the Tabletop (1) and align the
mounting holes on the Long Legs (3)
with the mounting holes on the Short
Legs (2). Use two Bolts (6) and Nuts
(7) to secure each Long Leg (3) to
the Table Top assembly. Tighten the
Bolts (6) and Nuts (7). See Figure C.
Leveling
Foot (5)
and Nut (8)
Long
Leg (3)
Leg Brace (4)
Short
Leg (2)
Tabletop (1)
Mounting
Holes
Figure C: Securing Leg Assembly to Tabletop (1)
4. Screw the four Leveling Feet (5) into the
bottom hole on Long Leg (3). Leave Nuts (8)
loose for now. Place the Tabletop Assembly in
the upright position, and adjust the Leveling
Feet as needed to level the Tabletop.
5. Place the assembled table in the upright
position. Adjust the Leveling Feet as
needed to level the table. When the
Table Top is level, turn it upside down
again, and tighten the Nuts (8) to lock
the Leveling Feet into position.
6. When the Tabletop (1) is level, turn it upside
down again, and tighten all four Nuts (8) to
lock the Leveling Feet (5) into position.
Tools and Tool Mounting
1. Tools can be mounted to Tabletop (1) in any
configuration. Make sure all tools are properly
attached and secured before beginning work.
2. Clamp: Insert Clamp (14, 11) into
any hole on Tabletop (1). Clamp may
be used to secure workpiece.
3. Stop Bar: Mount Stop Bar (9, 11, 15) into
any hole on Tabletop (1). Use Stop Bar to
guide or stop workpiece. Use in conjunction
with Threaded Adaptors (12).
4. Threaded Adaptors: Mount Threaded Adaptors
(12) underneath Tabletop (1). Use to convert
any Tabletop hole into an M10 threaded hole.
5. V-Blocks and V-Spacers: Place V-Spacer
(13) into any hole on Tabletop (1), then place
V-Block (10) on top of V-Spacer(13). Use to
support rounded workpieces or parts.
