７
out, the machine should be reset to its initiative.
3. Start : a green instantaneous button with a light (as for machines with top-plate , the same
button is a common one and there is no indicator light, other functions are normal.) This
button functions in three aspects: 1). When the turntable is in its origin and the film system
is at its lowest position, press this button, the machine will run automatically according to
the set parameter and program. 2) When the turntable is in its origin and at the same time
the film system is at the highest or lowest position (with goods loaded) while the machine is
ready, press the button and the machine will run automatically according to the set
parameter and program. When the program is completed, the machine returns to its origin.
The stopping location of the film system (up or below) depends on the set up –down times
of the system.3)when the turntable is in its origin and the film system is not in the lowest or
highest position, press the button, the film system will go to its lowest position, then the
machine will run automatic according to the set parameter and program
4. Speed : At the left, the button control the film carriage speed. At right, This switch is to
adjust the speed of the turntable . It is suggested that the speed be higher when the goods
are stable and vice versa.
5. Film Tension: one black button, in the middle of the switch “start”and switch “Stop”. This
switch is adjustable to set various film tension between the film system and the goods being
wrapped . Please adjust this switch to adapt to various goods being wrap . Note: an
over-tension will collapse the goods and the film, and even causes the so-called sandglass
phenomenon. Usually, the film wraps the goods being wrap tenderly and will wrap it tightly
later with its re-constriction. Turn clockwise and the tension will be enforced. The
pre-stretch adjusts the speed of the film output generator and the tension by adjusting the
speed-gap between the turntable and the generator. The Non-prestretch adjusts the damp
and the changeable tension of the stretching rubber roller. Therefore the pre-stretch on the
machine should be carried out by the coordination of adjusting the speed of the
rotating-plate while the block-stretch on the machine does not need this.
6. Manual/auto: one black button, two gears switch, Press this button to left ,it is manual
mode ,Press this button to right, it is auto mode.
7. Up/Down:one manual button, when the machine is in manual mode, press the button to
left ,the film carriage will be up, Press the button to right, the film carriage will be down
8. Stop: a saffron button with a light. This button is a self-block one with a light. Press the
button and the machine is in the state of pause. Repress the button and the machine
