Toro 73471 Manuale
The Toro Company – 1999
Printed in USA All Rights Reserved
Form No. 3323-484
Setup
Instructions
Model Numbers 73471, 73542,
and 73561—200000001 & Up
518xi, 520xi & 522xi Tractor
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Seat Assembly
Shoulder Bolt – 5/16”
Locknut – 5/16”
1
2
2Installing the seat
Steering Wheel
Boot Washer
Nut
Lock Washer
Trim Cover
1
1
1
1
1
Installing the steering wheel
Bolt – 1/4”-20 x .88” Long
Washer – 1/4”
Hex Nut – 1/4”-20
2
2
2Attaching the battery cables
Hitch Pin
Hairpin Cotter
Flat Washer – .50” I.D.
1
1
1Installing the drawbar hitch pin
Key 2Use in ignition and “Key Choice” switches
Operator’s Manual
Engine Operator’s Manual
Riding Mower Safety Video
1
1
1
Read before operating the tractor
Read before operating the tractor
Watch before operating the tractor
Installing the Seat
1. Mount the seat to the seat base using two 5/16”
shoulder bolts and lock nuts (Fig. 1).
2. Insert the seat switch wire through the center
opening in the seat base (Fig 1).
3. Push the seat switch wire connector into the wire
harness connector.
Set-Up Instructions
2
1
2
5
m–3453
3
4
6
Figure 1
1. Seat
2. Seat base
3. 5/16” shoulder bolt (2)
4. 5/16” Locknut (4)
5. Seat switch wire
connector
6. Opening for seat switch
wire
Installing the Steering Wheel
1. Install the boot washer onto the steering shaft
(Fig. 2).
2. Remove the plastic trim cover from the steering
wheel (Fig. 2)
3. Install the steering wheel onto the shaft,
carefully aligning the splines (Fig. 2).
Note: On manual steering models, be sure to
align steering wheel in the straight
ahead position. There is no fixed
straight ahead position on power
steering models.
4. Secure the steering wheel to the shaft with a lock
washer and nut (Fig. 2). Tighten the retaining nut
to 45–50 ft–lbs.
5. Install the trim cover on the steering wheel.
m–2482
1
3
2
4
5
6
Figure 2
1. Boot washer
2. Steering shaft
3. Steering wheel
4. Lock washer
5. Nut
6. Trim cover
Checking Front Wheel Toe–In
With the tractor on a level surface, check to make
sure the front wheel toe-in is between 1/8” and 1/4”.
For instructions on adjusting toe-in, refer to the
Maintenance section in Operator’s Manual.
Set-Up Instructions
3
Check to Insure that Steering
Linkage is Centered
1. With the tractor on a level surface, turn the
steering wheel fully to the left and check the
clearance of the left hand spindle stop to the stop
on the front axle. There should be a slight
clearance between the stops (Fig. 3).
m–4265
1
2
3
Front of Tractor
Figure 3
1. Left hand spindle stop
2. Axle stop 3. Clearance
2. Repeat for the right front tire in a right turn.
3. If the stops on one side hit, and on the other side
have clearance, shorten the tie rod on the side
that hits, and equally lengthen the tie rod on the
opposite side until both sides have clearance.
Recheck the toe in.
Checking Tire Pressure
Check front and rear tire pressure. The correct front
and rear tire pressure is 20 psi (138 kPa).
Activating the Battery
POTENTIAL HAZARD
•Battery electrolyte contains sulfuric acid
which is a deadly poison and it causes
severe burns.
WHAT CAN HAPPEN
•If you carelessly drink electrolyte you could
die or if it gets onto your skin you will be
burned.
HOW TO AVOID THE HAZARD
•Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber
gloves to protect your hands.
•Fill the battery where clean water is always
available for flushing the skin.
•Follow all instructions and comply with all
safety messages on the electrolyte container.
1. Remove the battery from the tractor (refer to
Removing the Battery in your tractor Operator’s
Manual).
Note: Never fill the battery electrolyte with
the battery installed in the tractor.
2. Remove the filler caps from the battery. Slowly
pour electrolyte into each cell until the
electrolyte level is up to the lower part of the
tube (Fig. 4). Use an electrolyte with a specific
gravity of 1.265.
Set-Up Instructions
4
1
2
3
1262
Figure 4
1. Fillercaps
2. Electrolyte 3. Lower part of tube
POTENTIAL HAZARD
•Charging battery produces gasses.
WHAT CAN HAPPEN
•Battery gasses can explode.
HOW TO AVOID THE HAZARD
•Keep cigarettes, sparks and flames away
from battery.
3. Leave the filler caps off and connect a 3–4 amp
battery charger to the battery posts (Fig. 5).
Charge the battery at a rate of 4 amperes or less
for 4 hours (12 volts).
4. When the battery is fully charged, unplug the
charger from electrical outlet, then disconnect
the charger leads from the battery posts (Fig. 5).
4
1
23
1254
Figure 5
1. Positive battery post
2. Negative battery post 3. Red (+) charger lead
4. Black (–) charger lead
5. Slowly pour electrolyte into each cell until the
level is once again up to “UPPER” line on the
battery case (Fig. 4), then install the filler caps.
6. Install the battery in the tractor and connect the
battery cables (refer to Installing the Battery in
your tractor Operator’s Manual).
Note: Do not run the tractor with the battery
disconnected.
Installing the Drawbar Hitch
Pin
Insert the drawbar hitch pin into the drawbar hitch
and secure it with a .50” I.D. flat washer and hairpin
cotter (Fig. 6).
Set-Up Instructions
5
2
1
3
m–2481
4
Figure 6
1. Drawbarhitch pin
2. Drawbar hitch 3. .50” Flat washer
4. Hairpin cotter
Checking the Wiring and
Fasteners
•Inspect the tractor for any loose electrical
connections and secure them as required. Check
the wire routing to make sure moving parts do
not interfere with wires and cause a short.
•Assure all fasteners are tight.
Burnishing the Clutch
The following break–in procedure must be performed
as part of pre–delivery service or when a new clutch
is installed.
Note: There must be a PTO driven
attachment installed to provide a load
in order to burnish the clutch facings
properly.
1. Run the engine at full throttle and engage the
clutch bringing the load to full speed. Then
disengage the clutch.
2. Let the load come to a full stop, then engage
again.
3. Repeat these procedures (1 and 2) 5 times.
Test Driving the Tractor
1. Check the oil level in the crankcase (refer to
Engine Oil in your tractor Operator’s Manual for
oil type, viscosity and crankcase capacity).
Note: When checking the oil level, slide the
dipstick all the way into the filler tube,
but do not screw the dipstick onto the
filler tube.
2. Check the oil level in the transaxle (refer to
Transaxle Fluid in your tractor Operator’s
Manual for oil type, viscosity and capacity).
3. Check to make sure all lubrication points have
been greased as shown in the Maintenance
section of tractor Operator’s Manual.
4. Fill the tank with unleaded regular gasoline with
an octane rating of at least 85. Open the fuel
shutoff valve and check the fuel hose and fittings
for leaks.
Set-Up Instructions
6
5. As applicable, check and test the operation of the
following:
•Engine, choke and throttle controls
•Gauges
•Headlights and taillights
•Indicator lights
•PTO clutch and brake
•Lift system
•Service and parking brakes
•Transmission controls
•Steering
•Tractor operation in forward and reverse
6. Test the operation of the safety interlock system
(refer to the tractor Operator’s Manual for the
correct procedure).
Altri manuali per 73471
1
Indice
Altri manuali Toro Taglia erba
Toro
Toro GT2100 Manuale utente
Toro
Toro 20056 Manuale utente
Toro
Toro GREENSMASTER 1000 Manuale utente
Toro
Toro TimeCutter MX50 79024 Manuale utente
Toro
Toro Z287L Z-Master Manuale utente
Toro
Toro 30410 Manuale utente
Toro
Toro 74824 Manuale utente
Toro
Toro Groundsmaster 223D Manuale utente
Toro
Toro 30473 Manuale utente
Toro
Toro 74390 Manuale utente
Toro
Toro 4613 Manuale utente
Toro
Toro Greensmaster eFlex 1800 Manuale utente
Toro
Toro TimeCutter MX3400T Manuale utente
Toro
Toro Greensmaster TriFlex 3320/3420 Manuale utente
Toro
Toro Reelmaster 5610-D Manuale utente
Toro
Toro Greenmaster Flex 1820 Manuale utente
Toro
Toro TimeCutter ZS 3200 Manuale utente
Toro
Toro Sand Pro 3040 Manuale utente
Toro
Toro 29642 Manuale utente
Toro
Toro 30241 Groundsmaster 228-D Manuale utente
Manuali Taglia erba popolari di altre marche
TALEN TOOLS
TALEN TOOLS AVR HGM30 Manuale utente
DEWEZE
DEWEZE ATM-725 Manuale operativo
Weed Eater
Weed Eater 180083 Manuale utente
Husqvarna
Husqvarna Poulan Pro PP185A42 Manuale utente
Better Outdoor Products
Better Outdoor Products Quick Series Manuale utente
Cub Cadet
Cub Cadet 23HP Z-Force 60 Manuale operativo
