Toshiba TDP-FF1A Manuale utente
OWNER'S MANUAL
LED PROJECTOR
TDP-FF1A
Before Using
Preparations
Operations
Others
2
SAFETY PRECAUTIONS
The lightning flash with arrowhead symbol, within an equilateral triangle, is in-
tended to alert the user to the presence of uninsulated “dangerous voltage” within
the product’s enclosure that may be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user
to the presence of important operating and maintenance (servicing) instructions
in the literature accompanying the appliance.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS AP-
PLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLT AGES ARE PRESENT IN-
SIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALI-
FIED PERSONNEL ONLY.
WARNING: Handling the cord on this product or cords associated with accessories sold
with this product, will expose you to lead, a chemical known to the State of
California to cause birth defects or other reproductive harm. Wash hands af-
ter handling.
MODEL NAME: TDP-FF1 USA only
TRADE NAME: LED PROJECTOR MODEL NAME: TDP-FF1
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
FCC NOTICE: This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. This
equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
USA only
3
Before Using
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RESPONSIBLE PARTY: TOSHIBA AMERICA INFORMATION SYSTEMS, INC.
9740 Irvine Blvd., Irvine, CA 92618-1697 U.S.A
Phone: (949) 583-3000
WARNING: Changes or modifications made to this equipment, not expressly approved by
Toshiba, or parties authorized by Toshiba, could void the user’s authority to
operate the equipment.
WARNING: This Class B digital apparatus complies with Canadian ICES-003. Cet appareil
numérique de la classe B est conforme à la norme NMB-003 du Canada.
USA only
CANADA only
CAUTION
LED RADIATION DO NOT STARE INTO BEAM OR VIEW DIRECTLY WITH OPTICAL
INSTRUMENTS. CLASS 2M LED PRODUCT.
MANUF ACTURED
SERIAL NO.
4
IMPORTANT SAFETY INSTRUCTIONS
CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUC-
TIONS GIVEN IN THIS OWNER’S MANUAL AND THOSE MARKED
ON THE UNIT. RETAIN THIS BOOKLET FOR FUTURE REFER-
ENCE.
This set has been designed and manufactured to assure personal safety. Improper use can
result in electric shock or fire hazard. The safeguards incorporated in this unit will protect
you if you observe the following procedures for installation, use and servicing. This unit is
fully transistorized and does not contain any parts that can be repaired by the user.
DO NOT REMOVE THE CABINET COVER, OR YOU MAY BE EXPOSED TO
DANGEROUS VOLTAGE. REFER SERVICING TO QUALIFIED SERVICE PER-
SONNEL ONLY.
1. Read Owner’s Manual
After unpacking this product, read
the owner’s manual carefully, and
follow all the operating and other
instructions.
3. Source of Light
Do not look into the lens while the
machine is on. The strong light
from the len may cause damage to
your eyes or sight.
2. Power Sources
This product should be operated
only from the power source indi-
cated on the marking label.
If you are not sure of the type of
power supply to your home, con-
sult your product dealer or local
power company.
For products intended to oper-
ate from battery power, or other
sources, refer to the operating
instructions.
4. Ventilation
Openings in the cabinet are pro-
vided for ventilation and to ensure
reliable operation of the product
and to protect it from overheating,
and these openings must not be
blocked or covered. The openings
should never be blocked by placing
the product on a bed, sofa, rug or
other similar surface. This product
should not be placed in a built-in
installation such as a bookcase
or rack unless proper ventilation
is provided or the manufacturer’s
instructions have been adhered to.
5
Before Using
5. Heat
The product should be situated
away from heat sources such as
radiators, heat registers, stoves,
or other products (including ampli-
fiers) that produce heat.
6. Water and Moisture
Do not use this product near water.
For example, near a bath tub, wash
bowl, kitchen sink, or laundry tub;
in a wet basement; or near a swim-
ming pool and the like.
7. Cleaning
Unplug this product from the outlet
before cleaning. Use a soft cloth in-
stead of liquid cleaners or aerosol
cleaners for cleaning.
8. Power-Cord Protection
Power-supply cords should be
routed so that they are not likely to
be walked on or pinched by items
placed upon or against them, pay-
ing particular attention to cords at
plugs, convenience receptacles,
and the point where they exit from
the product.
9. Overloading
Do not overload outlets; extension
cords, or integral convenience
receptacles as this can result in a
risk of fire or electric shock.
6
IMPORTANT SAFETY INSTRUCTIONS (continued)
10. Lightning storms
For added protection for this prod-
uct during storm, or when it is left
unattended and unused for long
periods of time, unplug it from the
outlet. This will prevent damage to
the product due to lightning and
power-line surges. However, while
it is thundering or lightning, do
not touch the apparatus and any
connected cable and/or equip-
ment. This will prevent you from
receiving the electric shock by an
electric surge.
11. Object and Liquid Entry
Never push objects of any kind
into this product through open-
ings as they may touch dangerous
voltage points or short-out parts
that could result in a fire or elec-
tric shock. Never spill liquid of any
kind on the product.
12. Do not place the product
vertically
Do not use the product in the
upright position to project the pic-
tures at the ceiling, or any other
vertical positions. It may fall down
and be dangerous.
13. Stack Inhibited
Do not stack other equipment on
this product or do not place this
product on the other equipment.
Top and bottom plates of this
product develops heat and may
give some undesirable damage to
other unit.
14. Attachments
Do not use attachments not
recommended by the product
manufacturer as they may cause
hazards.
7
Before Using
15. Accessories
Do not place this product on an
unstable cart, stand, tripod, brack-
et, or table. The product may fall,
causing serious injury to a child
or adult, and serious damage to
the product. A product and cart
combination should be moved with
care. Quick stops, excessive force,
and uneven surfaces may cause
the product and cart combination
to overturn.
S3125A
16. Damage Requiring Service
Unplug this product from the out-
let and refer servicing to qualified
service personnel under the fol-
lowing conditions:
a) When the power-supply cord or
plug is damaged.
b) If liquid has been spilled, or ob-
jects have fallen into the product.
c) If the product has been exposed to
rain or water.
d) If the product does not operate
normally by following the operat-
ing instructions. Adjust only those
controls that are covered by the
operating instructions as an im-
proper adjustment of other con-
trols may result in damage and will
often require extensive work by a
qualified technician to restore the
product to its normal operation.
e) If the product has been dropped
or damaged in any way.
f) When the product exhibits a dis-
tinct change in performance - this
indicates a need for service.
17. If glass components, in-
cluding lens, should break,
contact your dealer for
repair service.
This product incorporates glass
components, including a lens. If
such parts break, please handle
with care to avoid injury and con-
tact your dealer for repair service.
The broken pieces of glass may
cause to injury.
18. Servicing
Do not attempt to service this
product yourself as opening or
removing covers may expose you
to dangerous voltage or other haz-
ards. Refer all servicing to quali-
fied service personnel.
8
IMPORTANT SAFETY INSTRUCTIONS (continued)
19. Replacement Parts
When replacement parts are re-
quired, be sure the service techni-
cian has used replacement parts
specified by the manufacturer or
have the same characteristics as
the original part.
Unauthorized substitutions may
result in fire, electric shock, or
other hazards.
20. Safety Check
Upon completion of any service
or repairs to this product, ask
the service technician to perform
safety checks to determine that
the product is in proper operating
condition.
21. Do not leave thermalpaper
documents or easily de-
formed items on top of the
unit or near the air exhaust
for long periods of time.
The heat from the unit could erase
the information on the thermal
paper, or cause deformation or
warping.
22. Do not use the product in
a closed installation state.
Do not place the product in a box
or in any other closed installation
state. Otherwise it may overheat.
This could result in a risk of fire.
9
Before Using
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to
ship your projector. For maximum protection, repack the set as it was originally packed at
the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm location.
When the unit is exposed to such a change in temperature, moisture may condense on the
lens and the crucial internal parts. To prevent the unit from possible damage, do not use
the unit for at least 2 hours when there is an extreme or sudden change in temperature.
Place and Manner of Installation
• Do not place in hot locations, such as near heating equipment. Doing so could cause
malfunction, and shorten the life of the projector.
• Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening
their lives, and darkening the screen.
• Using this instrument near a TV or radio may cause interference to the images or audio
sound. If this happens, move it away from the TV or radio.
• Moving the projector from a low-temperature room to a high-temperature room may cause
condensation on the lens or internal parts in the instrument. If you continue to use it in
that situation, the malfunction may result. Ensure to wait until the condensation naturally
disappears.
• Do not use the projector while holding it in your hands or lap.
• Do not use the projector near a power source and the like, or in locations like a ship
or vehicle that are subject to vibration or shock. Doing so may lead to a malfunction or
shorten service life.
Avoid Volatile Liquid
Do not use volatile liquids, such as an insect spray, near the unit. Do not leave rubber or
plastic products touching the unit for a long time. They will leave marks on the finish.
If cleaning with a chemically saturated cloth, be sure to follow the product’s precautions.
IMPORTANT PRECAUTIONS
10
EXEMPTION CLAUSES
In the spaces provided below, record the Model and Serial No. located at the bottom of your
projector.
Model No. Serial No.
Retain this information for future reference.
• Toshiba Corporation bears no responsibility in the case of damages arising from natural
disaster such as earthquakes, lightning, etc., fire not liable to Toshiba Corporation, acts
by third parties, other accidents, or use under abnormal conditions including erroneous or
improper operation and other problems.
• Toshiba Corporation bears no responsibility for incidental damages (lost profit, work inter-
ruption, corruption or loss of the memory contents, etc.) arising from the use of or the
inability to use this unit.
• Toshiba Corporation accepts no liability whatsoever for any damages arising from not hav-
ing followed the descriptions in this Instruction Manual.
• Toshiba Corporation accepts no liability whatsoever for any damages arising from mal-
functions arising from combination with equipment or software that is not related to
Toshiba Corporation.
Altri manuali per TDP-FF1A
2
Questo manuale è adatto per i seguenti modelli
1
Indice
Altri manuali Toshiba Proiettore
Toshiba
Toshiba TDP-TW355J Manuale utente
Toshiba
Toshiba TLP-S10 Manuale utente
Toshiba
Toshiba TDP-T90AU Manuale utente
Toshiba
Toshiba TLP-X10E Manuale utente
Toshiba
Toshiba TDP-S3 Manuale utente
Toshiba
Toshiba TLP-251 Manuale utente
Toshiba
Toshiba TDP-T45U - XGA DLP Projector Manuale utente
Toshiba
Toshiba TDP-T98U Manuale utente
Toshiba
Toshiba TDP-MT8 Manuale utente
Toshiba
Toshiba TDP-MT500 Manuale utente
Toshiba
Toshiba TW300 Manuale utente
Toshiba
Toshiba TDP-T9 Manuale utente
Toshiba
Toshiba TDP-PX10 Manuale utente
Toshiba
Toshiba TLP541E Manuale utente
Toshiba
Toshiba Projector-Laptop Manuale utente
Toshiba
Toshiba TDP-SC35 Manuale utente
Toshiba
Toshiba TDP-WX5400U Manuale utente
Toshiba
Toshiba TLP790 Manuale utente
Toshiba
Toshiba TLP-X200 Manuale utente
Toshiba
Toshiba TLP-XC3000 Manuale utente
