TP-Link Pharos CPE220 Manuale utente

Installation Guide

Outdoor CPE

CPE210 / CPE220 / CPE510 / CPE520

Contents

Overview 01

Hardware Connection 04

Site Consideration 04

Connection and Installation 06

Lightning & ESD Protection 07

Software Conguration 09

Logging into the PharOS 09

Conguration for Typical Applications 11

Antenna Alignment 13

Specications 14

FAQ 15

Overview

TP-Link's Pharos series outdoor CPEs are dedicated to outdoor wireless

network solutions. This guide is applicable to products including CPE210,

CPE220, CPE510 and CPE520.

• Package Contents

Installation Guide

Outdoor CPE

CPE210 / CPE220 / CPE510 / CPE520

Pharos CPE Passive PoE

Adapter

Pole Mounting

Straps

Installation Guide

Power Cord

• LED Explanation

The following picture takes CPE520 as an example.

POWERLAN0LAN1

AP/AP Router mode:

All four LEDs remain solid.

Client/Bridge/Repeater/AP Client Router mode:

That the more LEDs lit will indicate better wireless signal strength.

Flashing: A device is connected to this port, and is active.

On: The CPE is powered on.

On: A device is connected to this port, but there is no activity.

• Panel Layout

Pharos CPE220/CPE520:

Shielded Ethernet

Port LAN0 (Passive

PoE in)

RESETShielded Ethernet

Port LAN1

Grounding

Terminal

Pharos CPE210/CPE510:

Shielded Ethernet Port

LAN (Passive PoE in)

Grounding

Terminal

RESET

Passive PoE Adapter:

Remote Reset

Press and hold for 8 seconds to

reset the CPE to its factory defaults.

Power LED

The Power LED is on when the

passive PoE adapter is working

normally.

Hardware Connection

1. Site Consideration

• Mounting Height

Ensure a clear line of sight between the wireless devices for an optimum

performance. An elevated location is recommended as obstacles like

trees, buildings and large steel structures will weaken the wireless signal.

See 'Q2' in 'FAQ' for details about how to calculate the minimum mounting

height of the devices.

Line of Sight

Side View

• Orientation

Install the CPE devices with the front facing the intended signal receiving

devices. You can orient the devices with the assistance of Google Maps,

GPS and some landmarks according to the horizontal beamwidth listed

below.

Models CPE210 CPE220 CPE510 CPE520

Horizontal Beamwidth 65° 60° 45° 45°

shenzhen

Line of Sight

Horizontal

Beamwidth

2. Connection and Installation

Please connect and install the device as shown in the gure below. The

following introduction takes CPE520 as an example.

Ethernet cable length up to 60m

You should prepare an adequate

Ethernet cable to connect the CPE

and the passive PoE adapter.

Shielded CAT5e (or above) cable

with ground wire is recommended

(refer to the next section).

Connect to a computer,

router or switch.

(Depending on your

intended usage and/or

network topology.)

At the selected site,

approximately align the CPE

to the direction that you

have oriented.

Slide to replace the cover

of the CPE when all

connections are nished.

LAN0

PoE LAN

3. Lightning & ESD Protection

Proper grounding is extremely important for outdoor devices.

By using shielded CAT5e (or above) cable with ground wire for the

connection and the provided PoE adapter (method 1), you can eectively

eliminate ESD attacks. If you use the general CAT5e cable for the

connection, then it is necessary to connect the grounding terminal of the

CPE to earth ground through grounding cable (method 2).

The following introduction takes CPE520 as an example.

CPE

Grounding

Terminal

Earth Ground

Two Methods:

PoE Adapter with

Earth Ground

Grounding

Cable

Shielded CAT5e (or above) Cable

with Ground Wire

Grounding Terminal and Cable

Shielded CAT5e (or above)

Cable with Ground Wire

Grounded 3-wire

Power Outlet

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali TP-Link Punto di accesso wireless

TP-Link

TP-Link Omada EAP653 Manuale utente

TP-Link

TP-Link TL-WA901N Manuale utente

TP-Link

TP-Link M7350 Manuale utente

TP-Link

TP-Link Auranet EAP115-Wall Manuale utente

TP-Link

TP-Link Deco BE85 Manuale utente

TP-Link

TP-Link TL-WA5210G Manuale utente

TP-Link

TP-Link AURANET EAP110-Outdoor Manuale utente

TP-Link

TP-Link Auranet EAP120 Guida rapida

TP-Link

TP-Link PHAROS SERIES Guida rapida

TP-Link

TP-Link AURANET CAP300-Outdoor Manuale utente

TP-Link

TP-Link AP300 Manuale utente

TP-Link

TP-Link 54Mbps Wireless Access Point TL-WA501G Manuale utente

TP-Link

TP-Link Omada EAP115-Wall Manuale utente

TP-Link

TP-Link Auranet EAP225 Manuale utente

TP-Link

TP-Link Omada EAP115 Manuale utente

TP-Link

TP-Link omada OC200 Manuale utente

TP-Link

TP-Link CAP1200 Manuale utente

TP-Link

TP-Link Deco E4/W2400 Manuale utente

TP-Link

TP-Link TL-WA901ND Manuale utente

TP-Link

TP-Link WR702N Manuale utente

TP-Link

TP-Link Omada EAP110 Manuale utente

TP-Link

TP-Link TL-PA4010 Manuale utente

TP-Link

TP-Link TL-WA801ND Manuale utente

TP-Link

TP-Link AP9650 V1 Manuale utente

Manuali Punto di accesso wireless popolari di altre marche

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuale utente

Ubiquiti

Ubiquiti NanoStation NSM2 Manuale utente

Cisco

Cisco Aironet 1550 Series Manuale utente

Aruba

Aruba IAP-335 Manuale utente

Advantek Networks

Advantek Networks AWN-AP-54MR Manuale utente

IP-COM

IP-COM AP355 Manuale utente

Buffalo

Buffalo AirStation WLA-L11G Manuale utente

EnGenius

EnGenius EnStationACv2 Manuale utente

D-Link

D-Link DAP-3662 Manuale utente

xG Technology

xG Technology xMax CN1300 Manuale utente

Widelink

Widelink ezWave WAP-1100 Series Manuale utente

Edimax

Edimax CAP1200 Manuale utente

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuale utente

Aruba

Aruba AP-203R Manuale utente

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuale utente

CreatComm

CreatComm TB5F Manuale utente

SineDigital

SineDigital MW-1500AP(H) Manuale utente

Draytek

Draytek VIGORAP 902 Manuale utente