44971/000 - Smart System Tool Cabinet
4
Instruction Manual
English
1. TIPS FOR PROPER
PRODUCT USE
For your safety, please read this manual
carefully before installing the equipment.
Installation should be performed by trained
technicians. The safety messages shown here
are reminders to the installer to use extreme
caution during installation and training about
the system.
There are many variations in the procedures,
techniques, tools and parts for installation
due to varying workshop congurations.
Because of the great installation versatility,
the manufacturer cannot anticipate or provide
advice or safety messages to cover all
situations. It is the technician’s responsibility to
fully understand the equipment being installed.
It is essential to use suitable service methods
and to perform the installation in a proper and
acceptable manner that will not endanger your
safety, the safety of others in the work area, the
end user, or the equipment being repaired.
It is assumed that before the system is
installed, the operator has an understanding
of the general tool control system. In addition,
it is assumed that the operator has the proper
hand and power tools required for installation,
operation and training in a safe location.
These safety precautions should always be
followed, including:
1. Read all instructions.
2. Keep your work area clean and organized.
Disorder can lead to accidents.
3. Be careful, as burns/injuries may be
caused by contact with hot and/or moving
parts.
4. Do not use electric tools or equipment
with a damaged power cord, or if the
equipment has been dropped or damaged,
until it has been examined by a qualied
agent.
5. Do not let the power cord hang over the
edge of the table, work bench or countertop,
or come into contact with hot manifolds or
moving fan blades.
6. If an extension cord is required, a power
cord with a current rating equal to or
greater than that of the equipment should
be used. Power cords with rating lower than
the equipment’s power cord can overheat. Be
careful to arrange the extension cord so that it
cannot be tripped over.
ATTENTION! When using an extension
cord, use waterproof plugs and outlets.
7. For faster charging, the product should
be charged while the equipment is o.
8. Let it charge fully before storing. The power
cord can be removed from the equipment and/
or wound around the equipment when storing
it.
9. To reduce the risk of re, do not operate
the equipment near open containers of
ammable liquids, gases and powders.
10. Adequate ventilation must be provided
when working with internal combustion
engines.
11. Keep hair, loose clothing, ngers and all
body parts away from moving parts.
12. To reduce the risk of electric shock, do
not use on wet surfaces or expose to rain.
