Trango Broadband Wireless Access5830™User Manual
User Manual Rev 1
Copyright 2001-2003 Trango Broadband Wireless, A division of Trango Systems,
Inc. No part of this publication may be reproduced in any form without the
written permission of the copyright owner.
The information in this publication is subject to change without notice. Trango
Broadband Wireless shall not be liable for errors contained herein or for
incidental or consequential damages in connection with the furnishing,
performance, or use of this manual or the equipment it refers to.
FCC Information:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with these instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
correct the interference by one of more of the following measures:
1) Reorient the antenna;
2) Increase the separation between the affected equipment and the unit;
3) Connect the affected equipment to an outlet on a different circuit from that
which the receiver is connected to;
4) Consult the dealer and/or experienced radio/TV technician for help.
FCC ID Numbers:FCC ID: NCYM5830SAP60
FCC ID: NCYM5830SSU
FCC ID: NCYM5830SSUEXT
CANADA: TBD
IMPORTANT NOTE:
Intentional or unintentional changes or modifications not expressly approved by the party
responsible for compliance must not be made. Any such modifications could void the user’s
authority to operate the equipment and will void the manufacturer’s warranty.
To maintain compliance with the FCC's RF exposure guidelines, both units must be operated at least
20 cm from any person. This is necessary to insure that the product is operated in accordance with
the RF Guidelines for Human Exposure which have been adopted by the Federal Communication
Commission.
