WARNING
1.The area heater is intended for outdoor spaces. The installation must conform with local codes or,
in the absence of local codes, with the Australian Standard AS/NZS 5601.
2.Refer to the data label for the confirmation of gas type to be used.
3.The gas manifold supply pressure must be regulated at 2.75 kPa utilising at AGA approved regulator
(supplied with heater).
4.Never connect a non-approved gas cylinder.
5.Only use up to a 9kg LPG gas cylinder.
6.The minimum distance from non-protected combustible materials shall be 2m.
7.Change the gas cylinder in an amply ventilated area, away from any ignition source (candle,
cigarettes, other flame producing appliances).
8.Check that the regulator seal is correctly fitted and able to fulfil its function.
9.Do not obstruct the ventilation holes of the cylinder housing.
10.Close the gas supply at the valve of the gas cylinder or the regulator after use.
11.In the event of gas leakage, the appliance shall not be used or if alight, the gas supply shall be shut
off and the appliance shall be investigated and rectified before it is used again.
12.Check the tubing or the flexible hose (periodically and each time the cylinder is changed). If it
shows signs of cracking, splitting or other deterioration it shall be exchanged for a new hose and
regulator of the same length and must be AGA certified. Read the instructions before installation and
use.
13.This appliance must be installed, and the gas cylinder stored in accordance with the Australian
regulations.
14.Do not obstruct the ventilation holes of the cylinder housing.
15.Do not move the appliance when in operation.
16.Shut off the valve at the gas cylinder or the regulator before moving the appliance.
17.The Gas hose and connections must be changed within the prescribed intervals.
18.Use only the type of gas and the type of cylinder specified by the manufacturer.
19.In case of violent wind particular attention must be taken against tilting of the appliance.
20.Keep the instructions for future reference.
21.Do not connect the gas cylinder directly to the appliance without a regulator.
22.The tubing or the flexible hose must be changed within the prescribed intervals.
23.Use only the type of gas and the type of cylinder specified in these instructions.
24.The injector is assembled by manufacturer only.
