6
Button Layout for PreAmplifier SnowWhite
VOL+
Vol+10
CH+
MONO
MODE
DEVICE
VOL-
Vol-10
CH-
DISPLAY
MUTE
ON/OFF
=
The image above shows the control interface of the Director on the left and on the
right a translation of the active symbols for the SnowWhite into easy-to-understand
text. Only the buttons with text in the right image are available for the Amplifier
component type. For individual function descriptions, such as MODE, please refer to
the user manual for the SnowWhite.
After you have installed the batteries the Director will automatically be in the Amplifier
component type mode. From the factory, the Director is set to control the TRV100
preamplifier. If the SnowWhite does not respond to the remote commands, it can be
that the Director is programmed send special codes for the TRV100. If this is the
case, press and hold the and buttons at the same for approx. 3 seconds to
program the remote to send the RC-5 code set for the SnowWhite.
Batteries:
The Director uses two 1.5 Volt AAA batteries. In order to install the batteries, you
must first remove the bottom plate. To do so, please unscrew the screws that secure
the bottom plate with the supplied wrench.
Use only quality batteries to help protect your remote from batteries that may leak
damaging fluid into the Director. The use of rechargeable batteries is also possible.
Empty batteries should be replaced as soon as possible. If you plan not to use the
Director for some time, it is recommended that you test the batteries before next
usage.
Furniture and Unit care:
Supplied with the Director are four soft rubber feet to be applied to the bottom of the
remote. We recommend that you place them above the screws that hold the bottom
