3.1 Make sure all
of
the parts are intact contained 2 (Front Wheel Fork
Assembly),
12
(Connecting Bolt), 4 (RearWheel Connecting Board), 3
(Supporting Tube
),
13
(Pad), 14 (Connecting bolt), 8 (CylinderAssembly),
6 (MastAssembly), 5(Supporting Clamp Structure).
3.2 Join 2 (FrontWheel ForkAssembly), 4 (RearWheel Connecting Board). 3
(Supporting Tube) togetherfirmly with 12 (Connecting Bolt) as showed in
picture.
3.3 Join 13 (Pad), 5.6.8(Mast & Supporting Clamp Assembly & Cylinder
Assembly) and 3(Supporting Tube) together finnly with
14
(Connecting
bolt).
3.4 Replace
the
screw plunge on the top
of
8 (Cylinder Assembly) with
(ventilated screw plunge).
3.5 Make suresupporting clamp structure lifts smoothly withoutload.
3.6 Make sure supporting clamp structure lifts smoothly, wheels move agilely,
and brakes are available under
the
rated load.
4. WARNING
4.1 Neveroverload this truck beyond its rated capacity.
4.2 Place
the
drum in a low position when does not
lift
4.3 Raise the drum
just
awayfrom the ground when transportit,
do
notneed
to
lift
it
higher.
5.
OPERATION INSTRUCTION
5.1
Lift
Drum
Move th'e truck until its supporting clamp structure(5) touch the drum,
tighten descending valve lever(15), kick the brake
of
rearwheel(9). Kick
the
P.edal
lever so that
the
upperbiter
of
supporting clamp structure(5) will
screw down to clamp the drum, then continue to kick the pedal lever
to
lift
-5
-
