READ THE INSTRUCTIONS BEFORE MOUNTING OR REPLACEMENT
•Performing any activity with the power supply on constitutes potential hazard of electric shock.
Prior to mounting, power supply must be switched off by using the main switch!
•Multichannel switch may only be connected to a properly functioning electrical system with
compliance with the applicable standards. Activities related to connection to the power supply are
to be commissioned to a person with appropriate authorization. The mounting must be performed
in accordance to the scheme provided.
•The importer/supplier bears no responsibility for damages resulting from failure to comply with
these instructions.
INSTRUCTIONS
Every multichannel switch set have unique RF communication code. This RF code can be programmed on
both the receiver and the remote control after the previous one is deleted first. Also, each remote control
can store only one RF control code, i.e., each new device must copy the RF code to the main one.
•Pairing new remote control
To add new remote controls, they need to have the same number of control channels and copy the RF
code of the main remote control. It is possible to add an unlimited number of remote controls.
1. Main remote control: Press and hold “5”key for 5 seconds. The indicator of the remote control
will flash quickly, means it enters the pairing code transmission status.
2. New remote control: Press and hold “2”key for 5 seconds.
3. Indicator of the new remote controller flash three times after successful code learning.
•Clearing RF Code from receiver
Connect the multichannel and turn the power
on.
1. The clearing operation should be finished
within 1 minute after it is powered on.
2. Unpairing operation can be performed
within the remote control range.
Press and hold the remote control “6”for 5
seconds. The indicator of the remote control
flashes quickly, means it enters the clearing
code transmission.
1. Remote controller will automatically exit
code transmission after 60 seconds, or by
pressing any key.
2. If the original remote control is lost, the
new remote controller can be used for
clearing operations.
The load flashes 3 times.
Clearing coding is finished successfully
•Pairing remote control to receiver
Connect the multichannel and turn the power
on.
1.It is necessary to clear the code of the
receiver first.
2.Pairing operation can be performed within
the remote control range.
Press and hold “5”on the remote control for 5
seconds. The indicator of the remote control
will flash quickly, means it enters the pairing
code transmission.
Remote controller will automatically exit code
transmission after 60 seconds, or by pressing
any key.
The load flashes 3 times.
Pairing is finished successfully
