Unior 1693EL.20 Manuale utente
www.uniortools.com
Remote control set
Set za daljinsko upravljanje
Unscrew and pull out the controller module - remove four screws at the bottom of enclosure (no need to disconnect cables from controller, it can be left
out of enclosure by hanging on the cables).
Turn-off the power key and
disconnect power cord
1693EL.20
EN
SLO
Unior d.d.,Kovaška cesta 10, 3214 Zreče, Slovenia, T: +386 3 757 81 00, F: +386 3 576 26 43, sales@unior.com, wwwuniotools.com
909682801
Install remote receiver into the socket connector on the bottom of controller. Caution! Remote receiver is electrostatic sensitive device. Avoid touching
the contacts of Receiver before it is installed into the socket. Install receiver precisely to predefined location, marked with white rectangle on the controller.
Plug-in the antenna connector into the controller. Attach the antenna into the antenna holder.
Receiving signal from remote controller depends of antenna position so
the self-adhesive holder must be attached as presentend on image.
Install the controller back into the enclosure and fix it with four screws.
Testing the Remote Controller system
- Plug-in the power cord and turn-on the key
- Press and hold the button Up on remote controller for about 2 seconds. The stand should start to move upwards
and should stop after releasing the button Up.
- Short press and release of button Up. The stand should start to move upwards until the press of button Stop on
remote controller before it reaches upper limit position.
- Repeat the same procedure for button Down and Stop on remote controller.
Close the enclosure rear cover and
attach it with screws.
Indice
Altri manuali Unior Telecomando
