Unisar Digital Thermometer Manuale utente

INTRODUCTION

Thank you for purchasing the BébéSounds®

Remote Fever Monitor. This Thermometer will

enable you to monitor your baby’s fever from

another room, 24 hours a day. With the Remote

Fever Monitor you will be immediately alerted

if your child’s temperature has spiked up.

The Remote Fever Monitor takes your baby’s

temperature abdominally. The Thermometer

clips to the waistband of your baby’s diaper,

pajamas, or the special belt provided. Be sure

the sensor is touching the skin and that your

baby is wearing clothing that covers the stomach

to avoid the loss of body heat. The baby’s

temperature is taken every 5 seconds and is

transmitted to the portable Parents’ Unit (the

receiver) every 10 seconds.

The Parents’ Unit monitors your child’s temper-

ature and can be set to alert you if it reaches a

certain level. If your child is not feeling well,

you will be immediately alerted if his/her tem-

perature starts to rise.

This product is recommended for use with

children under 8 years old.

Warning: Consult your doctor of there is a

pacemaker present. This product is not a toy.

Do not allow children to play with it. Keep out

of children’s reach when not in use. Always use

under adult supervision.

Use of the Remote Fever Monitor should not

replace a visit to your doctor. It is recommended

that you advise your doctor any time a

temperature is above 100°F/37.8°C.

NOTE: Rectal temperature readings are more

accurate than abdominal readings. Temperatures

taken abdominally may be .7°~1.4°F (.4°C~.8°C)

lower than rectal readings. For example, if the

Remote Fever Monitor registers an abdominal

temperature of 100°F, your child’s temperature

may actually be 100.7°-101.4°F. This differential

should be considered when monitoring your

child’s temperature.

The Remote Fever Monitor is a Personal Care

Product and cannot be returned to the retailer.

All exchange and refund requests should be

directed to the BébéSounds®Help Desk. Call us

toll free at 1-888-232-6476.

If you are having difficulty, have questions, or

need assistance, call our Help Desk toll free at

1-888-232-6476 Mon-Fri from 9:00AM-5:00PM

EST.

KEY FEATURES

• Your child’s temperature is taken every

5 seconds

• The thermometer transmits your child’s

temperature to your portable Parents’ Unit

every 10 seconds

• Alerts you if your child’s fever is rising

• Alarm can be set for 5 different temperature

readings: 98°F, 99°F, 100°F, 101°F, and

102°F/36.7°C, 37.2°C, 37.8°C, 38.3°C, and

38.9°C

• Alarm will sound if the Child’s Thermometer

loses contact with the skin or has been

accidentally turned off

• Child’s Thermometer is water resistant

• Small and lightweight design makes it

comfortable for both child and parent to wear

• Powers off automatically to ensure a long

battery life if the temperature has measured

below 91.4°F/33°C for more than 20 minutes

• Special belt included to insure thermometer is

secured against the child’s stomach

• Easy to read LCD display

• Temperature shown in Fahrenheit (F) or

Celsius (C)

BATTERY INSTALLATION

1. Replace the battery when the “low battery”

warning symbol appears.

2. Use a coin to rotate the battery cover (on the

back) counter-clockwise to open.

3. Insert a new 3-volt CR2032 lithium battery

with the anode (+) side facing up and close

the battery cover.

INSTRUCTIONS FOR USE

1. Turn on the baby’s thermometer by pressing

the power button for approximately 2 sec-

onds. The LCD display will show the

temperature data.

3. Turn on the Parents’ Unit by pressing the

power button for approximately 2 seconds.

The LCD display will show it is searching for

the signal from the thermometer. After

several seconds the LCD display will show

the temperature reading received from the

thermometer.

4. To switch between Celsius and Fahrenheit, press

the (S) button for approximately 2 seconds. Both

units have to be independently set.

Buzzer: An alarm for

abnormal temperatures

Warning Light: Alarm

LCD Screen

Set Button:

A. Push 2 seconds to

switch between

°C & °F.

B. Choose high

temperature (fever

warning

temperature point

Warning Cancel Button:

Temporarily cancels buzzer sound

Power Button:

A. Push 2 seconds to turn power on or off

B. Push to set the fever alarm temperature

LCD Screen

Set Button:

Push 2 seconds to

switch between

°C & °F

Power Button:

Push 2 seconds to turn

power on or off

2. Clip the thermometer to the

baby’s diaper, pajamas, or

our special belt, approxi-

mately one inch (2-3 cen-

timeters) to the left of the

belly button. If you are using

the belt provided, it’s best to

fasten it over the diaper or

pajamas to avoid any

possible irritation. Make

sure the temperature sensor

on the back of the unit is in

contact with the skin and that

your baby is wearing clothing

covering the stomach to avoid the loss of

body heat.

Child’s Thermometer

Parents’ Unit

• Information is being received

• Temperature is under the alarm

set point

• Temperature reading is at or

above the set point

• Signifies low battery

• Temperature above or below the

Monitor’s range

5. To set the alarm push the power button and

the LCD display will flash an alarm setting

and read “SET.” The temperature alarm has

five settings: 98°, 99°, 100°, 101°, and

102°F/36.7°C, 37.2°C, 37.8°C, 38.3°C, and

38.9°C. To change the alarm setting press

the (S) button once for each setting until you

reach the desired temperature.

Remember, temperature readings taken abdominally may be

.7°~1.4°F (.4°C~.8°C) lower than rectal readings. This differ-

ential should be considered when monitoring your child’s tem-

perature and when you set the alarm. For example, you may

want to set the alarm for 100 if you want to know if your

child’s fever reaches 101. (See Note on P. 3)

6. After you have set the alarm push the power

button again and the LCD screen will return

to the monitor mode showing your child’s

temperature.

7. The first time the Fever Monitor is used wait

approximately 20 minutes for the thermo-

meter to reach a fully accurate temperature

read. After the first time, no waiting period is

required.

8. If the alarm sounds, temporarily turn it off by

depressing the “Cancel” button on the

Parents’ Unit.

9. To achieve maximum transmission range,

avoid placing the Parents’ Unit on or close to

metal articles or electrical appliances.

Use of the Remote Fever Monitor should not replace a visit to

your doctor. It is recommended that you advise your doctor

any time a temperature is above 100°F/37.8°C.

LO/HI

APPROVALS AND APPLIED

STANDARDS

FDA approved. For home use only.

The following standards apply to design and/or

manufacturing of the product:

• ASTM Standard E 1112 • EN 60601-1

• EN 60601-2 • ETSI300-683

• ETSI 300-220

FCC Approved: OV4RT910

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) This device must accept any interference

received, including interference that may cause

undesired operation.

UNDERSTANDING THE SYMBOLS

10 11

CARE AND CLEANING

1. The Remote Fever Monitor is a delicate

electronic device. To insure proper functioning,

do not immerse either unit in water and avoid

dropping them.

2. Clean both units with a soft cloth moistened

with either water or alcohol. Never use an

abrasive.

3. Keep out of the reach of children and in the

storage case when not in use. The optimal

storage temperature is between -4°~140°F/-

20°~60°C.

4. Do not disassemble the thermometer.

If you believe your Remote Fever Monitor is

not operating properly, please check the

batteries first. If it still does not operate

normally, or you are having other technical

problems, please contact:

Unisar Inc.

15 West 36th Street

New York, NY 10018

Tel. 1-888-232-6476

TROUBLESHOOTING

Poor Reception

Cause: Child’s Thermometer is not sending a

signal or the distance between both units is

beyond the specified range for over 40 seconds.

Effect: Parents’ Unit will beep 3 times at 10

second intervals and the receiving symbol will

disappear and SCAN will appear.

Solution: Check the position of the thermometer

and/or move back into the transmission range.

Low Battery

Cause: Battery power is too low to operate the

unit.

Effect: Parents’ Unit will beep every 5 minutes

and the low battery symbol will appear.

Solution: Change the battery in whichever unit

is causing the problem or in both units.

Temperature Too Low

Cause: Thermometer lost contact with baby’s

skin or the baby’s temperature is too low.

Effect: The Parents’ Unit will beep for 10 sec-

onds.

Solution: Check your child and the position of

the thermometer immediately.

12 13

TECHNICAL DATA

• For household use only

• Consult your doctor before using if there is a

Pacemaker implanted

• Temperature measurement range:

62.6°~109.4°F/17.5°~43°C

• Temperature display range:

62.6°~109.4°F/17.5°~43°C

• Ambient operating environment:

60.8°~122°F/16.5°~ 50°C

• Ambient storage environment:

-4°~140°F/-20°~60°C)

• Temperature accuracy: +/- 0.3°F/0.2°C

between 95°~98.6°F/35.8° ~ 37°C; +/- 0.2°F/0.1°C

between 98.6°~102.2°F/37°~39°C; and

+/-0.3°F/0.2°C between 102.2°~105.8°F/39°~41°C

• Each unit requires one 3-volt CR-2032 lithium

battery (included)

• Transmission frequency: 433.92MHz

• Transmission range: approximately 90 feet/30 meters

• Recommended for use with children under 8 years old

• Factory calibration lasts approximately five years

• Battery life: approximately 12 months, 2 months if

used continuously

• For longest battery life remove batteries when

not in use

LIMITED PRODUCT WARRANTY

BébéSounds®Remote Fever Monitor, distributed

by Unisar Inc., has a limited warranty against

malfunctions for a period of one year from the

original purchase date. Battery life or damage

due to misuse or abuse is excluded from this

warranty.

In-Warranty Procedure

In the event service is required due to malfunc-

tion during the warranty period, Unisar Inc. will

replace or repair the product under warranty.

The repair or replacement of the malfunctioning

item will be free of charge. Repair or replace-

ment of the malfunctioning item is subject to

verification of the malfunction when delivered

to:

Unisar®Service Center

15 West 36th Street

New York, NY 10018 USA

Please enclose dated proof of purchase with

your return.

14 15

NOTES NOTES

If you are having difficulty, have questions,

or need assistance, call our Help Desk

toll free at 1-888-232-6476

Mon-Fri from 9:00AM-5:00PM EST.

The Remote Fever Monitor is a

Personal Care Product and cannot be

returned to the retailer. All exchange

and refund requests should be directed

to the BébéSounds®Help Desk

toll free at 1-888-232-6476.

Unisar Inc.

15 West 36th Street

New York, NY 10018

Tel. 1-800-232-1196

visit us at

www.bebesounds.com

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Unisar Termometro

Unisar

Unisar BR101 Manuale utente

Manuali Termometro popolari di altre marche

Delton

Delton 981A Manuale utente

Baker

Baker MM2P Manuale utente

Tarmo

Tarmo 320281 Manuale utente

Citizen

Citizen CTD 504 Manuale utente

TFA

TFA 14.1500 Manuale utente

Vive

Vive DMD1010 Manuale utente

Gotemp

Gotemp THB4002 Manuale utente

GREISINGER

GREISINGER G 1202 Manuale utente

Amprobe

Amprobe TMD-53W Manuale utente

Trotec

Trotec BP10 Manuale utente

Radiance instruments

Radiance instruments RT616 Series Manuale utente

Eurolec

Eurolec IR151 Manuale utente

Scaneo

Scaneo TS42B Manuale utente

Sper scientific

Sper scientific 800043 Manuale utente

Microlife

Microlife NC 200 Manuale di istruzioni

Motorola

Motorola MBP69SN Guida alla configurazione

The MeatStick

The MeatStick The MeatStick Manuale utente

Hama

Hama TH35-A Manuale utente