Copyright Notice: These instructions are a component of this accessory. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
40031058v.A
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may
result in damage or personal injury. Retain manual for future reference.
CAUTION: Keep the Foot Switch under the desk to avoid trips and falls.
CAUTIONS & WARNINGS
!
!
!
AI-FRM068-1.0
Step 3
Raise or lower your desk to your desired position for standing
or sitting by gently pressing the pedals of the Foot Switch with
your foot. The pedal on the left is used to raise the desk and the
pedal on the right is used to lower the desk.
NOTE: Do NOT stomp on the pedals with force or stand on the
pedals as this can cause permanent damage to the Foot Switch.
Pro tip: If you are using the Wireless Foot Switch in conjunction
with any of the UPLIFT Desk Advanced Keypads, follow the in-
structions included with your desk or keypad to set “Upper and
Lower Limits” as your preferred standing and sitting heights.
Once the limits are set, you can press and hold the up or down
pedals until the desk automatically stops at your desired seated
or standing height.
Foot Switch & Receiver Pairing
Your Foot Switch and Receiver will be paired at the factory
and you should never need to pair them again. However, if for
any reason your Foot Switch and Receiver become unpaired,
please follow these steps to pair them again.
1. Make sure the Receiver is plugged into the control box.
2. Use a small object such as the end of a paper clip to insert
into the small hole at the front of the Receiver to depress
the internal button. You will feel a tactile “click” of the but-
ton when it is depressed.
3. While holding the paper clip in the small Receiver hole,
press down on both the left and right Foot Switch pedals.
4. After about 2-3 seconds, you will see the green LED blink
indicating that the Foot Switch and Receiver are paired.
5. Press the up or down pedal to conrm the desk moves.
Low battery indication
Two new AAA batteries will provide approximately 3.2V. When
the voltage of the batteries falls below 2.4V, the LED indicator
will turn red in color. This indicates that it is time to replace the
batteries.
Depending on usage, it is estimated that new batteries will last
approximately six months before needing to be replaced.
Refer to Page 1, Step 2 for instructions on installing batteries.
Green
Red
