V-TAC VT-521 Manuale utente
WEEE Number: 80133970
INSTALLATION MANUAL
RECESSED HANGING EMERGENCY EXIT LIGHT
VT-521
SAFETY:
• Installaon of this luminaire should only be carried out by a qualified electrician or
competent person to the current IEE Wiring Regulaons (BS7671)
• Please isolate mains prior to installaon/maintenance
• Check the total load on the circuit, including when this luminaire is fied, does not
exceed the rang of the circuit cable, fuse or circuit breaker
• Please note the IP (Ingress of Protecon) rang of this luminaire when deciding the
locaon for Installaon
• This product is Class II double insulated
• This product is non-dimmable
INSTALLATION:
• Provide power to the required point of installaon,
• Cut a suitable aperture in the ceiling as per the cut-out details in Fig 1 ensuring that it
does not infringe with electrical cables, water/gas pipes or ceiling joists
• Connect the baery to the inverter via the plug and socket provided
• Connect the live and neutral to the push fit terminals on the PCB of the inverter (Fig 3)
• Remove 2 screws on top of the fing (see Fig 2)
Fig1
Fig2
Remove screws
Cable entry point
WARNING:
• This product must be disconnected from the circuit if subjected to any high voltage or
insulaon resistance tesng. Irreparable damage will occur if this instrucon is not
followed
• Recommended roune test procedure in accordance with BS5266
• Daily check – check that the status GREEN LED indicator is illuminated
• Monthly funconal test – simulate a mains supply failure for approx. 30 secs by
operaon of key switch or switching off a circuit breaker. Ensure normal supply is
restored aer test and the indicator status LED is illuminated
• Twice yearly conduct a one hour duraon test - simulate a mains supply failure for one
hour connuous test by operaon of key switch or switching off circuit breaker. Ensure
normal supply is restored aer test and the indicator status LED is illuminated
• Annual full three hour duraon test - conduct a three hour connuous duraon test.
Simulate a mains supply failure for three hour connuous test by operaon of key switch
or switching off circuit breaker. Ensure normal supply is restored aer test and the
indicator status LED is illuminated
• If the luminaire fails any of the above tests, please contact a qualified electrician.
Fig 3
Live (brown)
Neutral (blue)
LS
N
L
L
GENERAL:
The LEDs fied in this product are non-replaceable. The unit should be recycled in the
correct manner when it reaches the end of its life. Check local authories for where
facilies exist.
Clean with a so dry cloth only, do not use aggressive cleaning products or solvents
which may damage the fing.
GUARANTEE
• This product is only guaranteed against defects in manufacture.
• The warranty is valid for two years from date of purchase.
• The warranty does not cover damage caused by improper installaon or abnormal wear
caused.
• The manufacturer does not warrant damage to surfaces resulng from improper
removal Or installaon.
In case of any query/issue with the product you can reach out to us at [email protected]
Indice
Altri manuali V-TAC Attrezzatura di illuminazione
V-TAC
V-TAC VT-3528-60 Manuale utente
V-TAC
V-TAC VT-035 Manuale utente
V-TAC
V-TAC VT-768 Manuale utente
V-TAC
V-TAC VT-16010 Manuale utente
V-TAC
V-TAC VT-1230 Manuale utente
V-TAC
V-TAC VT-711 Manuale utente
V-TAC
V-TAC 7817 Manuale utente
V-TAC
V-TAC VT-061 Manuale utente
V-TAC
V-TAC VT-4121 Manuale utente
V-TAC
V-TAC VT-524-S Manuale utente
V-TAC
V-TAC VT-781 RD Manuale utente
V-TAC
V-TAC 8604 Manuale utente
V-TAC
V-TAC SMART LIGHT VT-5050 Manuale utente
V-TAC
V-TAC 80133970 Manuale utente
V-TAC
V-TAC VT-45010 Manuale utente
V-TAC
V-TAC VT-525 Manuale utente
V-TAC
V-TAC VT-ST42 Manuale utente
V-TAC
V-TAC VT-08 Manuale utente
V-TAC
V-TAC VT-8061 Manuale utente
V-TAC
V-TAC VT-511S Manuale utente
