Ventair VWF150AS Istruzioni per il montaggio

150mm wall mounted exhaust

fan with auto shutters

Installation and Wiring Instructions

Model: - VWF150AS

Please read instructions in conjunction with illustrations

Please save these instructions

READ INSTRUCTIONS IN CONJUNCTION WITH THE ILLUSTRATIONS

IMPORTANT

1. All fans must be fitted in accordance with AS/NZS3000 (known

as SAA wiring rules). This unit should be installed by a licensed

electrical contractor or similarly qualified person.

2. The fan should be sited away from direct sources of heat.

3. If the fan is installed in a room containing a fuel burning

appliance, the installer must ensure that the air replacement is

adequate for both the fan and the fuel burning appliance.

4. All regulations and requirements must be strictly followed to

prevent hazards to life and property both during and after

installation, and during any subsequent servicing and

maintenance.

5. This unit must only be fitted and adjusted by suitably qualified

personnel.

6. This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental capabilities,

or lack of knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person

responsible for their safety.

7. Children should be supervised to ensure that they do not play

with the appliance.

DESCRIPTION

The VWF150AS fan is suitable for bathrooms, kitchens and laundry’s where a higher rate

of extraction is required. These are available as wall mounted only (wall kit, not

provided).

FAN LOCATION

A short circuit of the airflow should always be avoided, (Fig.1.) by siting the fan as far

away as possible from, and opposite to the main source of, air replacement in the room.

FITTING INSTRUCTIONS

WALL MODEL

1. Cut a 155mm-160mm diameter hole through the wall and insert a suitable wall

sleeve. Slope the sleeve slightly downwards away from the fan. Cut to length and

cement or secure both ends into position flush with the wall faces.

2. Loosen the screw in the bottom of the grille and remove the front grille. Mark the

screw centres through the holes in the fan back plate. Drill, plug and screw into

position. Fix exterior grille into position with the louvres positioned downwards

Note: - The grille must comply with the standard requirements of your country to

prevent access to the fan’s impeller.

3. After installation, ensure impeller rotates freely and the shutters can open.

WIRING INSTRUCTIONS

WARNING: ENSURE THAT THE MAINS SUPPLY IS SWITCHED OFF BEFORE MAKING

ELECTRICAL CONNECTIONS.

The extraction fan is suitable for connection to 220-240V 50Hz supply. It is a class ll

double insulated product and MUST NOT be earthed.

Cable entry to the fan should be done through the cable grommet provided, this can be

moved for either recessed wiring through the back of the fan or surface wiring.

Electrical connections depend upon the type of fan being installed and the required

mode of operation. After wiring is complete replace the grille, turn on mains supply and

check operation.

A. VWF150AS

Single speed fan. Controlled by remote switch (e.g., light switch or Auto sensor) Fig.2.

For safe use and maintenance of this Fan, wiring must be carried out in

accordance with the current AS/NZS3000 and local supply regulations.

Shutter Operation

The shutters will open approximately one minute after the fan is turned on. The shutters

will close about a minute after the fan is switched off.

This product should not be disposed of with household waste. Please recycle

where facilities exist. Check with your local authority for recycling advice.

VENTAIR PTY.LTD 4 Capital Place Carrum Downs VIC 3201 -Made in the UK

411519A 1222

Fig.2

Indice

Altri manuali Ventair Fan

Ventair

Ventair WAL45-DC Manuale utente

Ventair

Ventair WAL75-DC Manuale utente

Ventair

Ventair Brook 4 Guida all'installazione

Ventair

Ventair Orbital 45 Manuale utente

Ventair

Ventair SPYDA SPY903NWH Manuale utente

Ventair

Ventair GYRO 200 Guida all'installazione

Ventair

Ventair GLA1203WH Manuale utente

Ventair

Ventair PRO-V Slimline VSLF100 Istruzioni per il montaggio

Ventair

Ventair STANZA STA1203WH-LR Manuale utente

Ventair

Ventair MANROSE SIERRA MR2DXWH Manuale utente

Ventair

Ventair SPINIKA Series Manuale utente

Ventair

Ventair FAN0530 Manuale utente

Ventair

Ventair Stanza STA1203WH Manuale utente

Ventair

Ventair PRO-V PVPX200WH Manuale utente

Ventair

Ventair Mixflow Istruzioni per il montaggio

Ventair

Ventair MALIBU MAL1404WH Manuale utente

Ventair

Ventair MALIBU Series Manuale utente

Ventair

Ventair HARMONY II Series Manuale utente

Ventair

Ventair DC 3 Series Manuale utente

Ventair

Ventair GYRO 250 Guida all'installazione

Ventair

Ventair SPYDAEC SPYEC1253WH Manuale utente

Ventair

Ventair ROYALE DC Series Manuale utente

Ventair

Ventair Z564EXTSS Manuale utente

Manuali Fan popolari di altre marche

ELTA FANS

ELTA FANS H03VV-F Manuale utente

Hunter

Hunter 20714 Manuale di istruzioni

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manuale utente

Hunter

Hunter Caraway Manuale di istruzioni

Panasonic

Panasonic FV-15NLFS1 Manuale utente

Kompernass

Kompernass KH 1150 Manuale utente

VES

VES FALA100/12V/TR Manuale utente

Vertiv

Vertiv Liebert DCD Manuale utente

Westinghouse

Westinghouse GFP Series Manuale utente

Venmar

Venmar KUBIX HRV PLUS Series Manuale utente

Maico

Maico ECR 31 Manuale utente

Sonnenkonig

Sonnenkonig Dinky Manuale utente

S&P

S&P ECOWATT HXBR Manuale utente

Wider

Wider IMP03369BH Manuale utente

Panasonic

Panasonic F-60DHN Manuale utente

Hinkley

Hinkley HIGHLAND Manuale utente

Broan

Broan 766BN Manuale utente

Premium

Premium PFS16022 Istruzioni per il montaggio