Vertiv Avocent Manuale utente

AVOCENT® MATRIX SWITCHING

SYSTEM MOUNTING BRACKET

Quick Installation Guide

590-1530-501A 1

The following instructions help you

install your Vertiv™ Avocent® Matrix

Switching System mounting bracket.

Should you require further assistance,

please contact Vertiv Technical Support.

Because mounting surfaces vary, the

Matrix switch mounting bracket does not

include mounting anchors. For ease of

description, it is assumed that wood

screws are being used. Depending on

the type of mounting surface, a dierent

type of anchor may be needed to secure

the mounting bracket.

ITEMS NEEDED:

• One mounting bracket

• Four #8 screws, minimum 3/4

inch long

• 1/16-inch drill bit

1. Preparing the mounting

location

Determine the best position for your

Matrix receiver. The bracket may be

mounted on a vertical or horizontal

surface with an appropriate

substrate.

CAUTION: For safe installation,

mount this bracket to a type of

material that can easily sustain the

weight of the Matrix receiver and

attached cables. Please use caution

in determining which screws are most

suitable to use, taking into account

the type of material to which the

bracket will be mounted.

NOTE: If you are mounting the

bracket on a vertical surface, orient

it so that the front of the Matrix

receiver faces the ceiling rather than

the ground.

Mark the holes on the surface where

the bracket is to be mounted. Use

the holes on the outer edge for

maximum strength. Drill four guide

holes at the marked positions.

2. Attaching the bracket

Hold the bracket in place and insert

one screw into each of the four

guide holes. Tighten the screws.

3. Installing the Matrix receiver

Line up the end points on the Matrix

receiver and slide the unit into the

bracket. Plug in any necessary

cabling.

Vertiv™ Avocent® Matrix Switching System Mounting Bracket

To contact Vertiv Technical Support: visit www.VertivCo.com

trademarks or registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co. assumes no

responsibility, and disclaims all liability, for damages resulting from use of this information or for any errors or omissions. Specifications are subject to change without notice.

2 590-1530-501A

Altri manuali per Avocent

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali Vertiv Rack e supporto