III. OPERATION OF REFRIGERATOR
Clean the inside before use.
Fix the shelves properly according to the instruction.
When use for the first time (or not use for a long time), you should adjust the
temperature to minimum and have the cabinet empty running for 2 hours, and
then adjust to the desired temperature.
When the power is connected, cooling system starts to work. The TEMP-ADJ
knob(thermostat) is set on certain position, which means that if the temperature
in the refrigerator reaches the point set, Self-control Temperature System stops
cooling system so the temperature in the cabinet rises gradually.
When the inside temperature rises above the set point, Cooling Self-control
Temperature starts to work again, the refrigerator enter into cooling circles.
When you want to change the temperature in the cabinet, You can make use of
the temperature setting knob to set the temperature.The temperature range is
6°C—12°C (± 1°C), after the temperature is set on one certain point and when
the temperature inside reaches this point, the automatic temperature control
system begin to work.
IV. Reversing the Door Swing of Your Appliance
This refrigerator has the capability of the door opening from either the left or
right side. The unit is delivered to you with the door opening from the left side.
Should you desire to reverse the opening direction, please call customer
service for reversal instruction or the chart following the installation of an
adjustment：
Pull out the cover and 4 pcs screws, see step 1 and 2.
Take out upper hinge, see step 3.
Pull out the other cover, see step 4.
Take out the whole door, see step 5.
Pull out the 4 pcs screw and take out the down hinge, see step 6 and 7.
Pull out the feet on anther side, see step 8.
Fix the down hinge into another side which pull out the feet by step 8;
Fix the whole door into the down hinge; then fix the upper hinge by
screws, and fix the cover.
