Viper AS4325B Guida utente

Start cleaning by placing the hands on the

safety switches

Use and maintenance

Operating guidelines AS4325B

July 2020

Turn on the machine and verify there is

enough battery power to complete the

work. Charge batteries if required.

Lift the deck by pressing the pedal Place the brush or the pad-holder under the

deck and Lower the deck or the brush/pad-

holder by pressing the pedal

With the machine on, press one of the safety switches to engage the brush/pad-holder, then

release it. If necessary, repeat the procedure until the brushes/pad-holder is engaged.

The squeegee is raised and lowered with the deck.

Check the solution level the red ball on the

left side of the machine.

Lift the squeegee up by hand until it locks in

up position and turn suction off for double

scrubbing. To go back to working mode,

use the red lever to release the squeegee.

and turn suction on again.

Press the + or – buttons to increase /

decrease the solution ow rate.

Remove the red cover, ll the tank with

clean water and use maximum temperature

40 degree. Add appropriate low foaming

detergent according to dosage information.

When scrubbing is complete, turn off

the machine to perform the following

maintenance

Maintenance

Operating guidelines AS4325B

July 2020

When scrubbing is complete, turn off the

on/off button to perform the following

maintenance.

Daily: Empty the clean water tank using

the solution tank drain knob under the

machine.

Daily: Empty the recovery tank using the

recovery empty hose. Bend the soft part

before removing the cap to control the

ow.

Daily: Inspect and rinse the oat ball cage

and inspect and clean the lid gasket if

required.

Local Viper dealer:

Phone number:

SN:

Daily: Remove the squeegee, and clean.

Inspect the blades and ip them or replace

them if required.

Daily: Leave the recovery tank lid open to

let the tank dry after it’s been cleaned to

avoid bad odor.

Daily: With the machine turned on and

the deck lifted, press the click off button

to release the brush/ pad holder then clean

and inspect before next use.

Daily: Charge the batteries: Connect

the battery charger cable to the electrical

socket. Light turns red when charging and

green when the charging is complete.

Weekly: Inspect the solution lter and

clean if required.

Altri manuali per AS4325B

3

Altri manuali Viper Macchina per pavimenti

Manuali Macchina per pavimenti popolari di altre marche

Nilfisk-Advance

Nilfisk-Advance Advance SC370 17B Manuale utente

Numatic

Numatic ET 4045 Manuale utente

HAWK ENTERPRISES

HAWK ENTERPRISES HP1513-180BRUTE Manuale utente

Mytee

Mytee 8070 Mytee-Lite Manuale utente

Kärcher

Kärcher B 140 R Manuale utente

Triple S

Triple S Ace 26T1 Manuale utente

Nilfisk-Advance

Nilfisk-Advance SW 750 Manuale utente

Tornado

Tornado Marathon 2000 98190 Manuale

Windsor

Windsor ADMIRAL Admiral 8 Manuale utente

Numatic

Numatic TTB 1117/100 Manuale utente

Tennant

Tennant 8210D Manuale utente

Nobles

Nobles Frontier Manuale del prodotto

lavina

lavina 21-X Manuale utente

KENT

KENT Edge 28B Manuale utente

Tennant

Tennant 215 Manuale del prodotto

Windsor

Windsor BDP 51/2000C Manuale utente

CleanFreak

CleanFreak DURA-18HD Manuale utente

Nilfisk-Advance

Nilfisk-Advance Warrior 34RST Guida per l'amministratore