PROLIFTSS.L. V.11.03 - Depósito legal y Copyright 2011. Todos los derechos reservados.
4. INSTRUCTIONS.
4.1 - Situate the lift on its transport wheels (T)
upon a flat and stable surface.
When erecting the lift in open air, the risk of
wind is prevalent.
Where wind speeds exceed 30 Km/h it is
essential to tie the lift. 2 lateral eye bolbs (X)
aresituatedatthetopofprofile2,wheretensors
shouldbeattachedandfixedonsecureandfirm
ground (NEVER ON A VEHICULE OR
ANYTHINGTHATCANMOVE).
4.2 -Removetheoutriggersfromtheirtransport
compartments(S)andplacethemintheworking
position (V) ensuring they are fixed with the
security locks (R). The long outriggers are
placed at thefront beneaththe load.The short
outriggers are placed atthe back.
4.3 - Removethe front support bars (BA)from
theirtransportcompartment(S)andplacethem
intheircorrespondingfixedposition(D)oneach
front outrigger and at the top of the first profile
(E) ensuring they are fixed with the pins
provided BU/P1.
To correctly fix the front support bars (BA),
adjust the support of the front outrigger by
turning the stabiliser handel in the necessary
direction.
Insert clips (BU) and security pins (P1).
Adjust the vertical position of the lift with the
stabilisers (Q) turning the handels so that the
spirit level is centred (F).
4.4 - Letgo oftransport securityB,remove the
forksandplacethemhorizontally.
Place thelifting carriageat the required height
so that the Line Array fliying grame can be
attached.
The careful positioning of the front outriggers
enables theLineArray tofit between themand
ease assembley on to the forks.
Support FAS-01 is to be fixed to the forks by
either 1 or 2 points. See fig. 1.
IftheLineArrayfliyiynggramehas4linkpoints
use theFAS-02supportwhichenablestheLine
Array tobe flownfrom4 points, see fig. 2.
BothsupportsFAS-01andFAS-02areinserted
on the forks as follows:
TheLineArraycabinetswillbeattachedtotheir
fliying grame with the angles calculated
according tothe acousticcoveragerequired.
This ensures the Line Array cabinets can be
curved in function with thenecessary degrees
required between them.
The system should be attached at the
necessary distance to achieve the required
curve.The last cabinet should not hitthe body
of the lift. See fig. 3.
To ensure the maximum security margin it is
necessarry to always attach the LineArray at
the minimum distance possible from the body
ofthelift.Thiswill meanthatthebottomcabinet
is as close as possible to the body of the lift.
See fig. 3A.
To avoid overloading do not seperate
uneccessarily the LineArray from the body of
the lift. See fig. 3B.
Quick Operation Guide ENGLISH
