weBoost DRIVE 3G-S Manuale utente
TM
Cellular Signal Booster
460101
Need help? www.WilsonElectronics.com Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
ENGLISH FRANÇAIS
Package Contents
Quick Install Diagram
Outside Antenna Installation
Running Antenna Cable
Connect Cable to Drive 3G-S / Power Supply Cord
Connect Power Supply
Dash Mount Bracket
NEED ASSISTANCE? WE CAN HELP!
Contact our U.S.-BASED CUSTOMER SUPPORT:
n Contact our U.S.- based customer support team at
n Go online for how to resolve the most common issues at
www.weboost.com/us/customersupport
n Find a weBoost Certied Installer on our web site at
www.weboost.com/us/installers
Installation is simple, but we’re here to make it even easier.
Your cell phone is an essential part of your life. weBoost is here to
ensure you have seamless connections on all your cellular devices.
The Drive 3G-S cellular signal booster is a effective solution to all
those times you have lost a call while driving your vehicle due to a
weak cell signal. Installation is simple and can be completed with
minimal tools.
Note: How It Works
Signal Received and
Transmitted
Power Supply
Outside Antenna
Product Registration
Thank you for purchasing this weBoost product. Please take time to
register your new product at our website:
www.weboost.com/us/productregistration
Registering is quick and easy, it only takes 2-3 minutes to complete.
Your information is secure, we don’t share or sell your information
to other third parties.
TM
Cellular Signal Booster
460101
Need help? www.WilsonElectronics.com Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
ENGLISH FRANÇAIS
3301 East Deseret Drive, St. George, UT 84790
web: www.weboost.com email: [email protected]
phone: 866-294-1660 local: 435-673-5021 fax: 435-656-2432
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
RF Safety: Any antenna used with this device must be located at least 8 inches from all persons.
FCC: PWO460006 IC: 4726A-460006
THE SIGNAL BOOSTER UNIT IS DESIGNED FOR USE IN AN INDOOR, TEMPERATURE-CONTROLLED
ENVIRONMENT (LESS THAN 150 DEGREES FAHRENHEIT). IT IS NOT INTENDED FOR USE IN ATTICS
OR SIMILAR LOCATIONS SUBJECT TO TEMPERATURES IN EXCESS OF 150°F.
Drive 3G-S Drive 3G-S
Quick Install Guide
For more information refer to full Install Guide at:
www.weboost.com/us/installguide/drive3G-S
Drive 3G-S Signal Booster
Mini-Magnet Antenna
DC Power Supply
USB Cable
Mounting Bracket
111507_Rev01_11.27.14
Outside Antenna Installation Running Antenna Cable Connect Coax Cables to Drive 3G-S
Connect Power Supply to Drive 3G-S Connect to Power Supply Mount Dash Bracket (optional).
Select a location on top of the vehicle to mount the Mini-Mag
Mount Antenna that is:
Run the Outside Antenna cable into the car. The cable is strong
enough that it may be shut in most vehicle doors without damaging
the cable. For a cleaner look, carefully pull down the door seal, run
the cable under the seal, and push the seal back into place. This
method reduces wear on the cable as the door opens and closes.
Connect the cable from the Mini-Mag Mount Antenna to the
connector on the bottom of the Drive 3G-S.
Plug the power adapter into vehicle’s 12V DC power supply. If your
Drive 3G-S is working correctly, the light will be green.
NOTE: If lights are not green on your weBoost booster, please refer
to the full install guide online or contact customer support at
1 2 3
4 5 6
DC Power Adapter
Vehicle’s Power Supply
Dash Mount Bracket
Drive 3G-S
nNear the center of the vehicle’s
roof.
nAt least 12 inches from any
other antennas.
nFree of obstructions.
nAt least 6 inches from any
windows (including sunroofs).
Connect the power cable to the connector on the bottom of the
Drive 3G-S.Slide cell phone into cradle (may have to adjust arms in
different slots to t your cell phone).
Mini-Mag Mount Antenna
Clean the area where the bracket is to be mounted with the alcohol
wipe included. Allow the area to dry. Peel the backing to expose
the adhesive and press the bracket onto the desired location on
the dashboard. Attach the Drive 3G-S by aligning the rectangular
hole on the back with the tab on Mounting Bracket pushing
downward.
Drive 3G-S
Altri manuali per DRIVE 3G-S
4
Altri manuali weBoost Estensione
weBoost
weBoost DRIVE X RV Manuale utente
weBoost
weBoost DRIVE 4G-X FLEET Manuale utente
weBoost
weBoost Home 3G Manuale utente
weBoost
weBoost Home 3G 463105 Manuale utente
weBoost
weBoost DRIVE SLEEK U470035 Manuale utente
weBoost
weBoost Drive 3G-X SmarTech III 470011 Manuale utente
weBoost
weBoost drive 3G-M Manuale utente
weBoost
weBoost DRIVE 4G-X FLEET Manuale utente
weBoost
weBoost Drive 3G-X Manuale utente
weBoost
weBoost DRIVE 4G-X OTR Manuale utente
weBoost
weBoost Basic Home Manuale utente
weBoost
weBoost Home 4G Manuale utente
weBoost
weBoost Home Complete 460045 Manuale utente
weBoost
weBoost Drive 3G-X Manuale utente
weBoost
weBoost 460059 Manuale utente
weBoost
weBoost 470019 Manuale utente
weBoost
weBoost 472061 Manuale utente
weBoost
weBoost 473105 Manuale utente
weBoost
weBoost Drive Reach RV Manuale utente
weBoost
weBoost Home MultiRoom Manuale utente
