3
3. Personal fall arrest and rescue systems, including the SRL-LE, must be inspected prior to each
use for wear, damage, and other deterioration. Defective components must be immediately
removed from service in accordance with the requirements of OSHA 29 CFR 1910.140 and
1926.502.
4. The complete fall arrest system must be planned (including all components, calculating fall
clearance, and swing fall) before using.
5. Users must have a rescue plan, and the means at hand to implement it, that provides for
the prompt rescue of the user in the event of a fall, or assures that the user is able to rescue
themselves. A fall over an edge may require special rescue measures.
6. Store the SRL-LE in a cool, dry, clean environment, out of direct sunlight, when not in use.
7. After a fall occurs on the system, immediately remove from service until a “competent person”
can make the determination for reuse or disposal.
USE LIMITATIONS
1. CAPACITY: SRL-LE’s used in leading edge applications are designed for users with a capacity
(including clothing, tools, etc.) up to 310 lb (141 kg) total working weight. The SRL-LE used in
overhead applications has a capacity (including clothing, tools, etc.) up to 400 lb (181 kg) total
working weight.
2. MATERIALS: The lifeline of the SRL-LE is 7x19 3⁄16 inch galvanized steel wire rope.
3. CORROSION: Do not leave SRL-LE’s in environments where corrosion of metal parts could
take place as a result of vapors from organic materials. Use near seawater or other corrosive
environments may require more frequent inspections to ensure corrosion damage is not affecting
the performance of the product.
4. CHEMICAL HAZARDS: Solutions containing acids, alkali, or other caustic chemicals, especially
at elevated temperatures, may cause damage to the SRL-LE’s. When working with such
chemicals, frequent inspection of this equipment must be performed. Contact Werner Co. with
any questions concerning the use of the SRL-LE around chemical hazards.
5. EXTREME TEMPERATURE: SRL-LE’s are designed to be used in temperatures ranging from
-40°F to +130°F (-40°C to +54°C). Protection should be provided for SRL-LE’s when used near
welding, metal cutting or similar activities. Contact Werner Co. with any questions concerning
high temperature environments.
6. ELECTRICAL HAZARDS: Use extreme caution when working near high voltage power lines due
to the possibility of electric current owing through the SRL-LE or connecting components.
7. HEALTH: Minors, pregnant women and anyone with a history of either back or neck problems
should not use this equipment.
8. RESCUE: In the event of a fall over the edge, special rescue measures may be required.
9. TRAINING: Do not use SRL-LE’s without proper training from a “competent person” as dened by
OSHA 29 CFR 1910.140(b) and 1926.32(f).
10. REPAIRS: Only Werner Co., or persons or entities authorized in writing by Werner Co., may
make repairs or alterations to the equipment.
ANCHORAGE REQUIREMENTS
ANCHORAGES
All anchorages to which the SRL-LE attaches must meet the requirements of ANSI Z359.2 and OSHA
29 CFR 1910 and 1926.
OSHA states:
Anchorages used for attachment of personal fall arrest equipment shall be independent of any
anchorage being used to support or suspend platforms and capable of supporting at least
5,000 pounds (22.2 kN) per employee attached, or shall be designed, installed, and used as part
of a complete personal fall arrest system which maintains a safety factor of at least two; and
under the supervision of a qualied person.
WARNING!
Not all fall protection and rescue components are rated for the same user weight capacity.
Only use components rated for the same weight capacity.
