Bambu Lab X1 258 x 258 v1
Maintenance:
After every print we suggest wiping with isopropyl alcohol and fresh paper towel, or even
better, quickly scuff and clean with 000 Steel Wool and alcohol and paper towel before
reusing. This will prevent contaminants from the filaments from building up.
Should the PEX ever loose its grip, use some Acetone and steel wool to remove any
residue that may have permeated the PEX top layer. You may also try common dish
detergent or vinegar and clean with water as these help break fats added to filaments with
effects.
Suggested Temperatures and Settings for the Bambu Lab X1:
Filament Bed Temp °C Hot End °C
PLA 60-65 190-220
* PETG 50 240-250
ABS/ASA 110 230-250
* For PETG there is a molecular similarity with PEX and PEI, Bambu sets their default temp settings
way too high in order to achieve faster prints, you need to be more careful with settings on PETG
and lower these.
Also never pry parts off, wait for the plate and the part to fully cool and flex off to remove.
Test all PETG on a small area, each are different, if you get bonding use some glue stick to create
a barrier layer. For a comprehensive explanation see pdf (found on Wham Bam Systems Support
Page): https://whambamsystems.com/install
Resources, Help, and Support:
Should you have any issues please refer to our installation guide, FAQ’s,
and additional support information on our website:
Please go to our page: https://whambamsystems.com/install
for more support and resources, and feel free to write us with any questions
Wham Bam thanks you for your support and welcomes any and all feedback!
