Whispbar K104W Manuale utente

K104W

Fitting Kit

EN Fitting Instructions for Basic Carrier

x 4

Revision No: 2C 1

Fitting Kit K104W

MAX kgs (lbs)

W/P WHD

Hyundai

Avante , 4dr Sedan 96-00 EU 75 kgs (165 lbs) 75 kgs (165 lbs)

Elantra , 4dr Sedan 96-99 ZA 75 kgs (165 lbs) 75 kgs (165 lbs)

Lantra , 4dr Sedan 96-99 EU 75 kgs (165 lbs) 75 kgs (165 lbs)

Lantra , 4dr Sedan Nov 95-01 NZ 75 kgs (165 lbs) 75 kgs (165 lbs)

Lantra , 4dr Sedan Sep 95-Oct 00 AU 75 kgs (165 lbs) 75 kgs (165 lbs)

Fitting Kit EN

K104W

First Time Installation

●Remove parts from inside the package and

check. Contact your dealer if any parts are

missing or damaged.

●This kit fits type A, B, C and D.

●These instructions show type A crossbar

fitted. They also apply to type B, C and D.

NOTE: Clamp images in these instructions may

not be representative of the clamps in this kit

Fitting Kit EN

K104W

●Use keys to remove covers.

●Use hex screwdriver to reverse adjusting

screw 10 turns.

●Press adjusting screw and pull crossbar

legs out. Refer to the crossbar instructions

for crossbar adjustment method.

●Ensure each end of the crossbar is

adjusted equally.

Fitting Kit EN

K104W

●Remove locking screw.

●Attach clamp to each leg. NOTE; clamps

may have labels showing their positions on

the vehicle (For example; "Front Right").

●Refit locking screw so that it goes through

the hole in the clamp. Do not begin to

tighten the locking screw.

Fitting Kit EN

K104W

●Fit rubber pad (supplied with crossbar) to

foot.

●Make sure the pad fits into the holes

underneath the foot.

Fitment

●Pull back rubber seal to expose fixed points

on vehicle body.

●Remove screws from the vehicle's fixed

points

Fitting Kit EN

K104W

●Place crossbar on vehicle. Minimum

recommended spacing between the bars is

700mm (27 1/2") (unless otherwise stated).

●Clamps onto anchor points under rubber

door frame mouldings

●Press adjusting screw to adjust the leg

positions on the crossbar.

●Tighten adjusting screw to 5 Nm (3.7 ft lb)

hand tight.

Fitting Kit EN

K104W

●Replace screws back through holes in

clamp and vehicle body. Tighten screws.

●Refit rubber seal over the clamp.

●Tighten locking screw on both legs evenly.

●Check crossbar is securely attached to the

vehicle.

Fitting Kit EN

K104W

●Use keys to fit and lock covers

CAUTION: Recheck all fasteners immediately after

a load is applied to the crossbars.

Regularly check screws are tight.

Fitting Kit EN

K104W

Maintenance

●Clean the car roof and surfaces of the

product that will be in contact with the car

roof.

●Follow the fitting instructions for fitting the

product to your vehicle. Make sure all steps

are carried out in order.

●Set crossbars a minimum distance of

700mm (27 1/2") apart where no other

distance is specified in the fitting

instructions. This is especially important

when carrying long loads.

●Check unit is securely attached whenever

you refit it to the vehicle. If the unit feels

loose, refer to the fitting instructions and

readjust.

●Some glass/panoramic roofs and radio

antennae may not be able to be used when

the product is fitted.

●Do not modify this product.

●Refer to the maximum permitted load

capacity specified in the fitting instructions.

Do not exceed the vehicle manufacturers

roof load rating if it is lower than the

maximum load capacity specified in the

fitting instructions.

●Loads should not overhang the sides of the

product and be evenly distributed with the

lowest possible centre of gravity.

●Long loads should be secured with non-

elastic straps to the front and rear of the

vehicle.

●Objects with pointed ends (e.g. ski poles)

should be carried with the pointed ends to

the rear of the vehicle.

●Remove all loose or removable objects

from the load prior to loading.

●Make sure all loads are securely fastened

with non-elastic straps. Check regularly

during longer journeys.

●A loaded roof rack system can alter the

performance of your vehicle. Be especially

aware of the effects of side winds,

changing of direction, and braking

performance. Avoid rapid acceleration and

deceleration. Drive carefully.

●Note that the total height of the vehicle

increases when upright loads are carried.

●Products should be locked during transport

if they have locks fitted.

Indice

Altri manuali Whispbar Accessori per automobili

Whispbar

Whispbar K447W Manuale operativo e di installazione

Whispbar

Whispbar K001W Manuale utente

Whispbar

Whispbar WB201 Manuale utente

Whispbar

Whispbar K983W Manuale utente

Whispbar

Whispbar K453W Manuale utente

Whispbar

Whispbar K369W Manuale utente

Whispbar

Whispbar Prorack K539 Manuale utente

Whispbar

Whispbar K944W Manuale utente

Whispbar

Whispbar K862W Manuale utente

Whispbar

Whispbar K451W Manuale utente

Whispbar

Whispbar K310W Manuale utente

Whispbar

Whispbar K562W Manuale utente

Whispbar

Whispbar K726W Manuale utente

Whispbar

Whispbar S53W Manuale utente

Whispbar

Whispbar K822 Manuale utente

Whispbar

Whispbar K157W Manuale utente

Whispbar

Whispbar K716W Manuale utente

Whispbar

Whispbar K600W Manuale utente

Whispbar

Whispbar K855W Manuale utente

Whispbar

Whispbar K1218 Manuale utente

Whispbar

Whispbar K901W Manuale utente

Whispbar

Whispbar K867W Manuale utente

Whispbar

Whispbar K585W Manuale utente

Whispbar

Whispbar K647W Manuale utente

Manuali Accessori per automobili popolari di altre marche

James Baroud

James Baroud Odyssey Manuale utente

Motorola

Motorola i50sx Manuale utente

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuale utente

Feniex

Feniex T3 Manuale utente

Renault

Renault 77 11 423 180 Manuale utente

Kia

Kia E8300-4D000 Manuale utente

Brink

Brink 756843 Manuale utente

v.link

v.link CI-VL2-PC-HSD Manuale utente

Viking

Viking Stack-Rack Guida rapida alla configurazione

Aries

Aries 203015 Manuale utente

Choetech

Choetech AT0005 Manuale utente

ZZ2

ZZ2 ZZAIR-PRO Manuale utente

Holman

Holman 4A80L Manuale utente

Thule

Thule 2075 Manuale utente

Motorola

Motorola T325 Manuale utente

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guida all'installazione

DV8

DV8 FBJL-02 Manuale utente

Prorack

Prorack K1163 Manuale utente