Workzone WZEN 20 Manuale utente
Quick Set-Up Guide
GB IRE WZEN 200151 649 1500 1890 946244 www.einhell.co.ukAFTER SALES SUPPORT
Continued overleaf...
1) Unpack the Electric Staple Gun
a) Open the carton carefully and
remove all items:
- Electric Staple Gun
-400 x 10 mm Staples
- 100 x 14 mm Brad Nails
b) Ensure you have all items before you
discard the packaging.
6
7
3
4
5
2
1
Fig 1
1 Trigger
2Trigger interlock
3 Stapling controller
4Magazine slide
5Magazine
6Filling level indicator
7Electric Staple Gun head
Fig 7
Fig 5 Fig 6
ELECTRIC STAPLE GUN
Fig 2
A4
Fig 3
4
Fig 4
b
USING THE ELECTRIC STAPLE GUN
IMPORTANT: Read all the safety warnings in the User Instructions before you start
using the Electric Staple Gun.
IMPORTANT: Ensure you wear/use all the appropriate Personal Protective Safety
equipment while you are using the stapler.
EASY STEPS TO GETTING STARTED
GB IRE WZEN 200151 649 1500 1890 946244 www.einhell.co.ukAFTER SALES SUPPORT
EASY STEPS TO GETTING STARTED - CONTINUED
2) Inserting the staples or nails (Fig. 2-6)
• Remove the Mains Plug from the wall socket.
• Press the lever (a) on the magazine slide (4) downwards (Fig. 2).
• Pull the magazine slide (4) to the rear as far as the stop (Fig. 3).
• Fill the magazine with staples (Fig. 4-b & 5).
• When you ll the magazine with nails, make sure that these
rest against the left inner side (Fig. 4 & Fig. 6) of the magazine.
• Then slide the magazine slide back in until it stops and snaps
noticeably into place.
IMPORTANT: It must be possible to move the magazine slide without applying
much force. Watch out for jammed staples and nails.
3) Triggering shots
The built-in trigger interlock prevents the Electric Staple Gun from being
triggered accidentally.
Triggering is only possible as follows:
• Push the trigger interlock (2) into the 'ON' position.
• Press the head of the Electric Staple Gun against the material
and operate the trigger (1).
4) Maintenance
There is a risk of staples becoming jammed particularly when the Electric
Staple Gun is held at any angle when operated. In this case, switch the
tool o immediately and remove the Mains Plug from the wall socket.
IMPORTANT: Always remove the Mains Plug from the wall socket before
doing any work on the Electric Staple Gun.
Quick Set-Up Guide
ELECTRIC STAPLE GUN
IMPORTANT: Refer to the User Instructions for all other information.
Altri manuali per WZEN 20
1
Indice
Altri manuali Workzone Pistola sparachiodi
