YASKAWA DS031 Manuale utente

Yaskawa Electric America, Inc – www.drives.com

02Y00025-0515 Page 1 of 3

Date: 08/28/01

Remote Digital Operator (NEMA 4/12) Option,

Model DS031 & DS033 for GPD 305/J7

Introduction

The remote digital operator kit allows a digital operator to be mounted up to 3 meters from the GPD305/J7. The

kit includes:

1. One remote operator interface attachment

2. One gasket

3. One Digital Operator membrane cover

4. Four screws & nuts

5. Eight rubber washers

6. One RS-232 remote operator interface

7. One cable either 1 meter (DS031) or 3 meter (DS033) in length.

Hardware Installation

WARNING

HAZARDOUS VOLTAGE CAN CAUSE SEVERE INJURY OR DEATH. LOCK ALL POWER

SOURCES DRIVE IN “OFF” POSITION.

1. Disconnect all electrical power to Drive.

2. Verify power has been disconnected by using a voltmeter to check for voltage at incoming power terminals

(L1, L2, and L3).

3. Wait for the DC bus capacitors to completely discharge.

4. Remove contents from package. Verify that the above mentioned parts are included:

5. install the RS-232 remote interface. First, remove the screw on the front cover of the drive. Next, remove the

small square cover located above the control terminals to access CN1. Install the RS-232 remote interface by

positioning the interface directly above the CN2 connector. Press down on interface until all three tabs snap

into place.

6. Re-attach the front cover and tighten the screw down.

Yaskawa Electric America, Inc – www.drives.com

02Y00025-0515 Page 2 of 3

Date: 08/28/01

Remote Digital Operator (NEMA 4/12) Option,

Model DS031 & DS033 for GPD 305/J7

Flush Mounting. Mount the Digital Operator as follows.

1. Cut the Remote Operator mounting panel as shown in Fig. 1.1

Figure 1.1 (Dimensions in Inches, not actual size)

2. Install the Remote Operator on the front side of the panel. Use four stainless screws and four rubber

washers (one rubber washer per screw). See Figure 1.2

FIGURE 1.2

Yaskawa Electric America, Inc – www.drives.com

02Y00025-0515 Page 3 of 3

Date: 08/28/01

Remote Digital Operator (NEMA 4/12) Option,

Model DS031 & DS033 for GPD 305/J7

Surface Mounting. Mount the Digital Operator as follows.

1. Cut the Remote Operator mounting panel as shown in Fig. 2.1

Figure 2.1

(Dimensions in Inches, not actual size)

2. Apply the gasket to the front side of the digital operator. Install the remote operator from the rear side of panel.

Insert the screws through the front side of the panel and then mount the washers and nuts to the rear side of the

panel. Tighten screws gradually from the front side of panel. Refer to figure 2.2 for further installation directions.

3. Connect one end of the cable to the CN1 connector on

the drive and the other end of the cable to the RJ-45

receptacle on the back of the Digital Operator.

This completes the installation process.

Figure 2.1 Remote Operator Installation

Questo manuale è adatto per i seguenti modelli

Indice

Altri manuali YASKAWA Controllori

YASKAWA

YASKAWA J1000 CIMR-JC series Manuale utente

YASKAWA

YASKAWA Z1000 CIMR-ZU*A Series Manuale utente

YASKAWA

YASKAWA V1000 Series Manuale di installazione e funzionamento

YASKAWA

YASKAWA PROFINET V1000 Manuale utente

YASKAWA

YASKAWA CIMR-G7U Manuale utente

YASKAWA

YASKAWA CIPR-GA50C series Manuale utente

YASKAWA

YASKAWA CIPR-GA50C series Manuale del proprietario

YASKAWA

YASKAWA 050-1BA00 Manuale utente

YASKAWA

YASKAWA J1000 CIMR-JC series Manuale utente

YASKAWA

YASKAWA Servopack CACR-SR Series Manuale utente

YASKAWA

YASKAWA MOTOMAN DX100 Manuale utente

YASKAWA

YASKAWA V1000 Series Manuale utente

YASKAWA

YASKAWA 1000 Series Manuale utente

YASKAWA

YASKAWA iQpump Guida alla configurazione

YASKAWA

YASKAWA PG-X2 Manuale utente

YASKAWA

YASKAWA PS-V10S Manuale utente

YASKAWA

YASKAWA iQpump 7 Manuale utente

YASKAWA

YASKAWA CIMR-LC2A0018 Manuale utente

YASKAWA

YASKAWA 1000-Series Manuale utente

YASKAWA

YASKAWA MOTOMAN FS100 Manuale utente

YASKAWA

YASKAWA A1000 HHP Manuale del proprietario

YASKAWA

YASKAWA SI-EL3/V Manuale utente

YASKAWA

YASKAWA E7 Drive Manuale utente

YASKAWA

YASKAWA Motoman DX200 Guida rapida

Manuali Controllori popolari di altre marche

Digiplex

Digiplex DGP-848 Istruzioni operative

Sinope

Sinope Calypso RM3500ZB Manuale utente

Isimet

Isimet DLA Series Style 2 Manuale di installazione

LSIS

LSIS sv-ip5a Manuale utente

Rockwell Automation

Rockwell Automation 1769-L31 Manuale utente

Airflow

Airflow Uno hab Manuale utente

ABB

ABB ACS580-01 drives Manuale utente

Panasonic

Panasonic GM1 Series Manuale utente

Emerson

Emerson SW93 Manuale utente

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuale utente

Panasonic

Panasonic FP? Positioning Unit RTEX Manuale utente

Samson

Samson Type 5824 Manuale di servizio

Alpha IP

Alpha IP MIOB 21001 Manuale utente

Siemens

Siemens OpenAir GMA 1 Series Manuale utente

Surecom

Surecom SR-629 Manuale utente

Fishman

Fishman TriplePlay Manuale utente

Regulus

Regulus SRS1 T Manuale utente

3M MicroTouch EX113 Manuale utente