ZOS Halo Manuale utente
HALO Preserver
Cartridge
Cartridge Tube
Batteries ( LR44, QTY. 2 )
Holder
( with blank cartridge )
COMPONENTS:
Light Housing
Preserver Body
Cartridge
scan for instructional video
WWW.ZOSWINE.COM/GETSTARTED
3-0021-19a
•Remove blank Cartridge from HALO preserver and discard.
•Remove new Cartridge from Cartridge Tube.
•Shake new Cartridge for 5 seconds before installing into
HALO.
•Thread new Cartridge into Preserver Body.
DO NOT OVERTIGHTEN OR CRUSH.
•A BLUE LIGHT indicates HALO is now operating properly and
ready for testing.
•Immediately after installing new Cartridge, insert HALO
into Holder and install cap.
•EXPOSURE TO AIR SIGNIFICANTLY REDUCES
CARTRIDGE LIFE.
Unscrew Light Housing from Preserver Body and install both
batteries into Light Housing.
Install Batteries
Install Cartridge
SET UP
SEE OUR INSTRUCTIONAL VIDEO
WWW.ZOSWINE.COM/GETSTARTED
•Always test HALO before each new bottle by following the.
TESTING CARTRIDGE instructions above.
•Once you’ve confirmed the Cartridge is good (GREEN LIGHT),
insert into wine bottle immediately.
•A GREEN LIGHT will flash with any bottle motion,
indicating proper operation.
•HALO will not seal in some screw cap bottles
( necks are too large ).
•At least one glass of wine should be removed from bottle
before inserting HALO.
•To preserve Cartridge life, place HALO back into the
bottle immediately after pouring.
TESTING CARTRIDGE
USING HALO
•To perform a test, pull HALO out of Holder and reinsert firmly.
•HALO will flash alternating RED/GREEN indicating
cartridge testing.
•A solid Green or Red light will appear after the flashing stops.
GREEN = Cartridge is ready for use.
RED = Cartridge needs to be replaced.
•Always retest the Cartridge with each new bottle.
•HALO should immediately be returned to Holder, when
not in use.
•Remove blank Cartridge from HALO preserver and discard.
•Remove new Cartridge from Cartridge Tube.
•Shake new Cartridge for 5 seconds before installing into
HALO.
•Thread new Cartridge into Preserver Body.
DO NOT OVERTIGHTEN OR CRUSH.
•A BLUE LIGHT indicates HALO is now operating properly and
ready for testing.
•Immediately after installing new Cartridge, insert HALO
into Holder and install cap.
•EXPOSURE TO AIR SIGNIFICANTLY REDUCES
CARTRIDGE LIFE.
•Remove Cartridge and place into Cartridge Tube before
replacing batteries. Replace using two LR44 batteries.
Battery Replacement:
•Verify Cartridge is screwed in completely.
( Do not over-tighten or crush ).
•Change Batteries
No Lights:
Cleaning:
•When needed, clean HALO using a damp cloth only.
•HALO is not dishwasher safe, do not submerge in water.
•EXPOSURE TO AIR SIGNIFICANTLY REDUCES
CARTRIDGE LIFE.
•Always store in Holder when not in use.
•Do not lay bottle on its side when using HALO.
•Shake new Cartridges for 5 seconds before installing
into HALO.
IMPORTANT NOTES
MAINTENANCE
Indice
Altri manuali ZOS Utensile da cucina
Manuali Utensile da cucina popolari di altre marche
NEFF
NEFF T4..3.. Manuale utente
Schulte-Ufer
Schulte-Ufer De Luxe i Series Guida alla configurazione
Cook's Companion
Cook's Companion IntelliBag Series Manuale utente
Breville
Breville EW30XL Manuale utente
Genius
Genius Nicer Dicer Chef S Manuale utente
Swissmar
Swissmar 3-in-1 fondue set Istruzioni operative